1st Gen Lunchtable Thread - General Discussion

http://premierpowerwelder.com/shop/...nner-1995-2004-3-4l-v-6-premier-power-welder/

Want. Dunno where I'd install the weld box but... Want.

 

Mini version - http://premierpowerwelder.com/shop/...95-2004-3-4l-165-amps-v-6-mini-welder-system/

 

Just bite the bullet and carry this in the bed at all times if a welding machine on the truck is what you want to accomplish.
https://m.northerntool.com/shop/too...9prCfZwsI3Zn-WRO3n-u8W5OXi6pyjkBoCWbkQAvD_BwE

 

That won't fit under the hood tho.

 

Fancy

 

Whats the output amperage of the control box thingy? Surely it isnt the full 165 that the alternator is putting out...

Anything less than 80 amps is useless for stick welding. Even with the small 3/32" rods. Could run a 6010 or 6011 on less but those rods just result in frustration if you dont use them often enough imo. I like a 3/32" 7018 on 80 amps for 3/16" steel.

 

I can see how that would work well. I've been using Super Lube for a decade on a variety of applications.

 

https://www.instagram.com/p/B-knwRYHkTQ/?igshid=1a364mt635np9

 

Any need a diff?
2003 Tacoma Front Differential And Steering Rack
https://classifieds.ksl.com/listing/59277726

 

Check the site but those welding systems use high frequency to operate, so 2/3 less amps than a standard welder. I had a friend that had one on his jeep, they do work well.

 

OMG, how hard can it be to understand...

 

No shit huh

 

Eh, we all gotta start somewhere.

Good thing hes learning on a 1st gen. A 2nd or 3rd gen would require you to undo the UCA from the ball joint, or the LCA from its ball joint.

 

Didn't need to do either on the 4runner and it's the same suspension as those.

 

Actually, I think I removed the LBJ bolts, my bad. Super easy tho.

 

I found it to be not possible to remove the coilover without undoing one or the other on my dads 08. Tried for probably an hour before giving in and popping the ubj loose

 

Bored, scrolling through netflix and I find @Speedytech7 avatar

 

It's Legosi

 

Its a newer Anime that I never heard of before

 

Finally whipping the Duramax to break in the break pads and shake down. Steering is nice and tight.

Still needs an alignment bad and the closest place with a rack for a CCLB truck is an hour away so I'll probably trailer it there next Saturday lol