1st Gen Lunchtable Thread - General Discussion

Probably. Better to be over than under if you're balancing a tent up there over rocky terrain and don't want to destroy your bed sides too quickly. Entire rack still comes in at just under 50lbs, which isn't bad.

Glad you guys like them

Bed racks are a lot of work, I don't need too much business, hahahahaha

 

hurry up and pay it off so we can get a shop together with dan

 

Farther out I drive the more difficult itll prove to be

Idk where ill go really

Was talking to xtreme earlier about cheap as hell places in AZ (and nice too)

 

true, but they are worth it and more imo

 

you in a free state?

 

Work tomorrow, I'm out

Hopefully my batteries don't die while I'm asleep

 

CA is far from free

 

your going to go nuts lol

 

Oh boy!

My new toy is here.

 

You forget though, I lived in IL as an LEO.

I know what freedom is.

 

yea but you been tainted with CA.

 

thats 10 years in a cali prison if your caught

 

Nah that’s just straight to the Gulag.

Do NOT pass Go.
Do NOT collect $200.

 

Leave this here

 

Just noticed dealers are starting to do core charges for CVs. Not sure if this has always been a thing but I don't remember seeing it when I was ordering my CVJ axles back in 2018. Conicelli has a manual hub axle for $117 with a $75 core charge.

 

I just started thinking about the pita that manual swapping and drive by wire to cable throttle swapping my truck will be

Id have to get a new ecu, harness, injectors, sensors, modules repin shit and that isnt thinking about the awd system... ive got a j shift but awd is cool

Holy crap

Would have been great to know than and buy the right truck

 

https://www.bankspower.com/i-137-mo...r-2000-2006-toyota-tundra-3-4l-4-0l-4-7l.html

hmmm. do i put a banks exhaust on the tundra or DIY an exhaust.. or get the magnaflow dual side exit... i kinda like the banks.. with the eventual headers i'd probably flow more than well enough for some nice power gains

the duals with x pipe and long tubes dyno a consistant 40 -50 more HP over stock. so this single exit 3" might hinder that a bit, maybe?

 

it depends on if your ordering a NEW part or a REMAN part. with the age of these trucks i doubt the NEW are even available anymore

 

I think about this every night

I may sell my abs hubs with good bearings delete the abs and run my tacomas spindles with no abs tone rings or wheel speed sensor holes

press in new bearings, get bigger dust shields and spindle gusset it while its off