1st Gen Lunchtable Thread - General Discussion

I say diy cause ive done it before but i have more time than money

I was going to go to bed than i started thinking about my truck

 

DIY will cost me about the same as this. because me being me i'll buy 304 stainless.

 

Its only money it comes and goes wether its to get into a club or a good meal or a car part or a date or a bill it will go

in a couple months most of what we buy now will mean nothing to us

Its what we save that counts

 

i plan on keeping this tundra for a long time. it serves a purpose while not being overly large like the new full size trucks or low on torque like the modern mid size trucks (the 3rd gen taco has the power.. but not the grunt of the 4.7, but both very close in size, tundra being a bit longer just a hair longer than a double cab long bed trud gen)

 

I agree toyotas offerings have drifted from the ideologies that made them in the last couple decades

 

Old bearings and race from the 100 series front 3rd still going good after 21 years and 235,000 miles. All replaced though.



Race wear.

 

They'll die if you actually use the tool

I get about 6 minutes out of a 2 AH battery on the M18 Angle Grinder at work. Roughly the same on the drills if Im using them hard. The 3AH aren't much better either, maybe 15 mins of constant use.

Last week I got one of the drills so hot the rubber jacket thing started melting off... But drilling 8 5/8" holes by hand in 1/2" cold rolled steel will do that to you. I think I ran back to the shop like 4 times for another charged battery while doing all that.


But yeah, my M12 impact driver isnt phased by lug nuts. But then again thats like all of 20 seconds of actual tool run time.

 

Got to wear masks at our desks now, feels weird even though we wear masks on the reg at work anyways.

 

Supposedly we are going to be issued masks soon.

 

Are you practicing for college discussion boards or wut

 

No it was 3am

 

He’s an awesome dude. Met him years ago when I found out my dads buddy knew him

 

Well who knew, hummer h3 trucks use a 13wg caliper from the factory

 

I wonder if they're cheaper if you order them for that fitment

 

I got Sunday off and I sent the gf out for spray paint. Just good ol Rust-Oleum semi gloss black. And to Menards for some plate steel lol.

 

Dick.

 

Well, they use a banjo bolt too instead of a hard line

 

Same offset?