1st Gen Lunchtable Thread - General Discussion

I have made a terrible mistake.

 

Holy shit

Would you like some rear trunk with your bondo

 

I overestimated what a "Thin" coat is.

 

I don't know how bad the trunk was but for small areas, automotive glaze works very well.

Spreads much thinner than bondo.

 

All I had was two cans of Bondo.

This was just so I could find the low areas.

 

Heres a tip I learned in high school collision class.

To find low spots, fold a terry shop rag over a few times and put your hand on it and go back and forth over the panel. The rag will amplify the low spots allowing you to feel them a lot easier. And it prevents that bondo mess you created. Hope you have a straightline air sander...

 

I've got a DA sander.

It was pretty flat to begin with, but I overestimated what a thin layer is.

 

This liquor delivery idea may catch on.

 

Eek

 

Thats a lot of bondo

Too much hardener hardened too quick before you could spread it

 

Puppy prison is ready

 

Bruh moment

 

wack

makes sense since there's no VSS

 

I thought you were painting that thing today??

 

my ass would have gone ahead and painted over it without any bondo

 

Me too. Spray paint can fill dents if sprayed on thick enough!

 

2K spray primer

 

I am. That's the bondo coat to spot low spots.

There ain't low spots anymore!

 

Nope, just jagged mountains of bondo.

 

Its called finishing putty