What Have You Done To Your 2nd Gen Tacoma Today?

What seat covers are these?

 

For the money, everything I've heard supports that would be a good choice. I pulled the trigger on this yesterday.

 

Blew out the frame a couple of weeks ago since winter is done. Reapplied rust prevention to the critical areas...especially around the cats.

Frame soaked inside and out. I'll redo it right before winter.

 

• Coverking Neosupreme Seat Covers

 

Toyota should have made the fenders trimmed from the factory. Looks way better.

 

The first time I remember someone with an upgraded horn, it was the Boys from Hazzard County. LoL

 

That would be the tits

 

This build is sick

 

If I created an idea that I didn't want copied the thing that I would never do is put it up on the internet.

But like someone else wrote being copied is the best form of flattery. People liked your idea and you should appreciate that, especially since you put it on the internet.

To each their own.

 

Anyone know if you can run a mountain hatch with the mobtown tailgate cap? I currently have both mobtown cap and plate on the gate and want to replace the plate with a mountain hatch board.

 

How many cans? How hard to do? My frame looks like I live by the ocean year round.

 

Nice Photoshop! Lol

 

I used 1 can to do those cat areas....most of it sprayed on the inside through the various holes on both sides of the frame. Then I spray a little on the outside and spread it around with a glove on.

Now come winter time...I'm closer to 3 cans. In addition to the cat areas I also do the leaf springs and bottom of the c-channel down either side of the frame.

I also give the intermediate shaft u-joint a couple of squirts at each oil change

I really like the Liquid Wrench rust inhibitor

 

Link to new trailer plug?

 

Those fenders look super clean!

 

Pulled the front diff actuator and soldered the connections.
Before


After


Also swapped front diff drain plug to the Lexus drain plug.

 

My beautiful wife got a fantastic birthday present. A bit of overkill for a Tacoma but if I ever get another 1 ton truck I'm set.
Old vs new.



Makes easy short work on the truck. Wish I'd of had it a couple weeks ago when I replaced my rear springs.

 

Nice jack! Those larger wheels on the new jack look way easier to move it around vs the typical.

 

Yeah they are a lot easier to work with. In fact the jack started to roll out of my garage unattended due to the very slight slope. It's just a little harder to slide in to position under the vehicle, but not by much. I'm not complaining at all though.

 

where did you get this? i like the wheels, both driveway options i use are pavers and steel wheels are a B!