NW WA Meet / BS Thread

should. i put a 4th gen 4runner axle into my tacoma

 

and a cv axle meant for a tacoma into my GX470

 

it equals 100% accuracy

I remember getting into contact with the CVJreman rebuilders @JimSnell recommended while on the hunt for some spare OEM CV’s. If i remember right they said they taco/gx and 4Runner uses were the same

 

This is exactly what I’m going to do

 

180% accurate

 

I would have if I was still filing single, getting married last year actually made me money.

 

Beats dying alone

 

so like i usually do, buy first figure stuff out later.
i bought a spacer claimed to work amazing for driveline vibes. my lift being more than modest i figured this would give more spline contact. this spacer mounts to the pinion end of the driveshaft. the previous owner had off the line vibes that this solved. is there a way to check #s to make sure stuff is correct?? i often get in over my head and have very few trucks to compare mine to. any tips guys? aside from quit messing with it.

 

If you thought safety meetings were boring, just wait till you have to do a digital one

 

I think Your best bet is a one piece

 

A few months ago, I was hoping to find a local place that offered the OSHA60 course, now it looks like online might be my only option.

Does anyone have any recommendation on which vendor to take this course from?

 

can you do them online?

 

yea, I’m sure you can but I was hoping to do it in person though as my attention span Is b short for online courses.

 

id rather suck start a shotgun

 

My safety meetings tend to look like...







but now look like...

 

ive been contemplating that.

 

drivelines nw gave me attitude when i asked. tom woods is the name i know. any recomedations?

 

Maybe try Driveline Service up in Bellingham.

 

What gear ratio do you have in the diffs?

I personally would never put a one piece in my Taco but a custom double cardan is on the short list. That will definitely eliminate vibes and should be cheaper than a whole new one piece

 

isn't there a mega driveline thread on TW? I remember reading through in-depth details on measuring angles and doing the math and shims and all that.