Whiskey Cabinet BS

I’m over crap weather.

 

Yeah the snow is piling up. It not so much on the streets or walks .. so there's that!

I will likely have to pull the Taco outside and set up my paint booth to get it finished.

 

Need a paint booth.

 

Screw that snow business - we're finally getting perfect weather. If it could stay like this year round...

 

I have one that I made of PVC and plastic sheeting... It's pretty fantabulous... And modular.

 

I saw this inflatable one. Looked pretty slick it had a recirc system and all.

 

I have a filtered fan at floor level ... It works for me...I'm searching for pics but I must have deleted them!

 

I’m all about home built solutions.

 

I decided against setting up the paint booth .. I wanted to see some results! Haha

A coat of primer for fun



No.. I'm not that bad of a painter... It's the reflections in the gloss black



Super shiny!

 

Very nice. Coming along great. Can’t wait to see the end results.

 

Looking very good! Now make 2! My bar top is getting full!

 

Well here's the finished look of the inside..still waiting on the finish for the doors so I'll post that if and when that ever happens.

The second shelf has two steps in it to display more bottles along with angle iron bracing along the back. The third shelf has angle iron on bother the front and the back to support the planned load on that shelf.

 

Damn that’s looking good.

 

It'll be better when it's reloaded too! Haha

 

Haha you're on your own! This one turned out more of a PITA than I wanted!

 

Was thinking one made with thick acrylic side lit and JD etched shelves.

 

I still haven't given up on the acrylic ... I'm just not satisfied with my results so far. I tried a couple more ideas during this rebuild but they failed to impress me.

 

I’m talking full shelf like either 3/4” or 1” thick so it’s stable. Drill all around the edge and embed the LEDs and then etch the JD logo in the center. Should test that out.

 

The price of such a shelf would scare most people away.
I even thought about laminating thinner sheets together to get a similar effect...and have the sheet in the middle the etched one. That way the top and bottom are both smooth... Again. The cost is somewhat high for that as well

 

Ya it ain’t cheap but done right is important.