1st Gen Lunchtable Thread - General Discussion

It's obviously gotta go in the flatbed.

 

Thanks
Oof is better than
PART OUT

 

No use for that. I can get a gte for like 1500 if i wanted a 2jz

 

From where, if that's true you could have a job buying those and turning them out for 2700+ cause that's the bare min for a GTE

 

I mean current setup is only good up to 55mph or so -- but my wheel tire setup is less than ideal

 

Leaves can be almost as flexy, but probably not off the shelf. Any of the setups require a lot of fine tuning to perfection

 

I guess what I'm saying is that it's not so difficult in any one aspect -- the cutting and welding is the easy part and it's just tedious adjustments to:

suspension geometry
steering geometry
brake lines
master cylinder
driveshaft
steering box
column to steering box
steering links
spring rates
shock valving

 

The shock mount looked better before I panicked and spewed FF all over it.
Don't think that small area got the hammer test but it did get Corroseal and paint. Now I've gotta clean off the FF and hope for a good weld

 

bring it on over and I'll weld it up for a sixxer

 

Thanks for the thought
I've got a flux core mig and 11ga.steel.

 

won our first warzone beotches!@

 

Wonder where all this goes

 

its been a while since ive asked. but it was a local guy in chicago that got them cheap
its been 2-3 years since ive inquired.

 

Front of the engine fall off?

 

ye yee

 

chop shop?

 

Fud apop wux dut?

 

Spoiler: long