What Have You Done To Your 3rd Gen Today?

A lot of cutting and hammering, A LOT!

 

Got the new headlights in

 

I can open it about 5 inches and that’s it with this setup. If you were to go a roll-up tonneau with this set up you could open it all the way since it rolls. They’re KB Voodoo high rise crossbars.

 

a couple more

 

Finished setting up and installing Tekonsha P3 brake controller and Curt weight distributing hitch with sway control. Tows like a dream now

 

Been debating on what tail lights I wanted upgrade to. I hated the chrome trim the OEM lights came with on the sides and wanted to go the black or smoked route. Was a little hesitant on the Winjet's at first due to all the threads and videos about blowing fuses. They must have upgraded their designs. These were 100% plug and play (although you do have to reuse some stock clips and bulbs.) I hooked the left side up wrong and was worried I, like others, I blew a fuse but it was just a simple flip and everything works fine with no fuse issues. I'm pretty satisfied with the finished look. Yes,I know the truck needs a wash lol

 

Had the truck interior cleaned, shampoo’d and steamed. My seats don’t have stains anymore and looks like when I first bought it

 

Woah i've never seen an AC prinus rack before!

 

Today:
OVTuned 2.0 04B04
91 Octane OLE
31"-33" Tire Size


All that war armor too much for the little V6?
Bring your truck back to life with OVTune.

No pedal commander, that is just a bandaid fix.

I like them, I have resonator tips on both ends.
However, I do have URD Ypipes, which makes the entire system raspy around 2.5k to 3k...

 

It’s their shorty

 

Go Hawks!

 

Welcome to TW!

 

But just shit canning the friendship adventure.......

 

My hand is tired from liking this...

 

I like the stripes. Where did you get them?

 

Switch to the other hand.

 

https://www.etsy.com/listing/789167967/classic-trd-race-truck-monochrome-racing?ref=yr_purchases

 

I installed a Warn VR EVO 12,000 pound winch onto my Southern Style Offroad bumper. I chose to move the control box rather than cut the grill brace. I think the worst part of the job was actually bolting the winch to the bumper. The front bolts have to be installed before setting the winch onto the bumper as the bolts need to go in on an angle, and then you can only fish an open-end wrench in to tighten the volts due to the underside skid plate on the bumper. It was otherwise just a bit of weight. It looks great and didn't have any impact on the front ride height, which really surprised me.

 

Done with all the mods for now. Maxtrax and pins as the “very last” mods installed... for now. Lol.

 

I said the same thing. I have more money now than I ever have and I haven’t bought one thing in a few months! I’m thinking 2” lift will me my next purchase. But I think I’m gonna wait for a while. Good looking truck.