What Have You Done To Your 3rd Gen Today?

Side note, I ordered a hitch skid from you guys yesterday. Can't wait for that bad boy! These Colorado rocks are rough on the ol rear end.

 

it's in the display mode, it was their last one, saving the crate for an end table maybe???

 

What Garmin are you running? I’m running the Garmin Overlander. Your photo looks like an iPad

 

thanks for the input guys ill figure it out. its going to be a long drive , 1hour plus. so maybe a trailer would make more sense.

 

Oh hell yea that gets me even more pumped! I'm not too concerned if I have to wait a bit longer for the new vendor considering the stay at home crap, and I'm all for higher quality parts. I'll keep an eye out for that email. Thanks man!

 

To each his own, I researched OV Tune, found it cost prohibitive, had the TSB applied and am quite happy with that. 6 or 7 hundred dollars vs. free was an easy decision for me.

 

If the mattress has metal springs in it don’t tie it down so tight as to bend the mattress as it will permanently distort them, don’t ask me how i know...

 

I just bought a dual gps also. How do you have your ipad mounted?

 

Nice. How did you mount these?

 

I see. Good idea for end table... I like barrel for end table so I could put round glass table on it. I do the home remodeling jobs. I plan to make wine rack out of the pallets.

 

good for you.

 

What light bar is this? N-Fab? How was the install? Happy with the design/function/build quality?

Finish seem durable?

I am not going to do a bumper, but plan to add individual lights (I have an association with a light company) I have been looking for a turnkey solution as I am in part of the country where custom stuff is not easily to source.

 

Damn that's a lot of shit! U stuffed all this behind the dash?

 

Yep it's an N-Fab bar and I'm very happy with it. The install took a couple hours, but it's rock solid. There's a post on here about trimming the radiator shrouds a lot less than the N-Fab instructions indicate and show how you don't have to remove the lower grill piece to install it FYI. I found mine on Amazon as a warehouse deal for $60 with prime shipping. The finish has held up to one full Alaska winter and summer with no issues.

 

@StormTroop425 looks GREAT! Mind if I ask what size/model tire you went with there?

 

I'm looking at the same kit. How much lift did you end up with?

 

Thanks! 285/75/16 BFG AT2! Not as stiff as I was expecting but much heavier. Love the look, I have zero issues rubbing right now, I'm just nervous I will have some rubbing issues fully loaded but time will tell. I don't do any serious wheeling but I like to get off the grid on occasion.

 

noice! that will be fun to put on

 

Awesome, thanks for sharing your opinion and experience, greatly appreciated.

I thought I would go that direction, but hoped for a consumer review.