What Have You Done To Your 3rd Gen Today?

I agree 100%.

 

Same- want one for my SR

 

Going to the dump?

Tough crowd!

 

Experience is a good teacher, I've learned some of my best lessons the hard way!

 

I'll take your SR when you done. Hate the '18 cheese grater. Not enough of a fan of the Pro grill to get one.

 

.. used my tail gate as a workstation for breaking in my new Traxxas Maxx while my pug chased it around everywhere. Pug approved

 

I feel your pain!!

 

Leveled on Bilstein 5100 up front with stock coils on 2nd clip
Along with new tires, 265/75/16 Wildpeak A/t
Only rubs full lock in reverse on oem OR wheels

 

Well a little drastic but most likely will work.

 

I'm getting the 5100s installed shortly using my OEM coils. What lift did you get on the 2nd notch from stock?

 

Nice!! got a thread on that build you can share?

 

That's the deal Cappy, remember my bluebirds? If the little buggers can see their reflection then they'll be trying to fight off that newcomer.

 

Good luck! Truck cover about the only thing that will work until nesting season is over.
I've tried everything but tying a house cat to the hood.

Here kitty kitty, nice kitty kitty.

 

I believe the guide from Bilstein said 2nd notch gives a 0.65 inch lift, which will leave you with some reverse rake still as mine did. If you move up to the 3rd I've read the ride gets noticeably more rough but the level should be perfectly even.

 

I pull a camper in the summer so I would rather the rear be a bit higher than the front. Looking at options.

 

Did a few little interior mods...
Grid-it panel in console, trunk storage net behind rear passenger seat, and those rubber mat inserts for the cup holders.

 

Funny thing is they don't even look at my wife's car but they are all over the truck. Maybe the red color attracts them.

 

Yeah it's bolted to the trans tunnel. The seat version has a flexable shaft that will shake when off road from what I've heard. (not very stiff) so I have another style brace on the way. This is early in my mock up so was not prepared to post yet. Parts are coming from Wash. so it will be a year or so....ahahahahhaha.
Zim

 

I also went with the 2020 grill, love it. I didn’t want to look like a lot of the other Tacoma’s on the road and I scored mine for $60.

 

Picked up a Hi Lift from a member a few weeks ago and hadn't anything to mount it. I had some Caliraised low profile ditch light brackets i had been sitting on ,and decided to see if i could used then to mount the jack. Got some T slot nuts from ebay cause Amazon showed delivery 3 weeks out. Got some other nuts, bolts washers and came up with the below set up. Still some more tweeking to do, but i think it might work.