What have you done to your Tacoma today? 1st Gen Edition

Could play a large role in it that's for sure.

 

There are a couple of seals and a stake nut involved.

Remove the 4 bolts that hold the front driveshaft to the flange. Mark the mounting orientation so you can put it back together the same way. When you remove the driveshaft you will see the stake nut. Remove the stake nut and the flange will pull off exposing the seals.

Here is the part numbers for my '02:

Front Output Shaft Oil Seal

$10 90311-41012 Type-T Transfer Case Oil Seal

90311-41012

Companion Flange Seal (small) 90312-23001

Stake Nut 90179-22016

You may be able to get away with not having to change the small companion flange seal. Depends on what you find when you get in there.

 

Picked up a nice used 20T Air/Hydraulic Shop Press today, ahead of a couple planned jobs. Seals and bearings (and brakes) in the rear end are beyond needed, and I can now rebuild my transmission when it comes time (the time is near.)
The air pump on the press needs rebuilding, ordering the parts Monday. Adding a foot switch and probably casters shortly.

 

It's not so bad. Output seal is most likely the culprit. Timmy-the-Toolman has a video outlining how to change this. All the part numbers and tools used are listed in the description, super detailed, makes it a cannot fail job. Timmy even gives Home Depot options for those of us who don't have all the fancy tools.
I did mine in a couple hours. Let us know how that works out!

 

Thanks it is a cage though haha

 

yesterday i put on my prinsu cab rack, and the day before i. Put my apbaja bumper and my badland 12k winch

 

No mine bolted right up.

 

I had to cut the pointy ends off my frame horns for my Apex to fit my 04. Seems some trucks have to and others don't have those pointy ends. Other than that it bolted up

 

Measured mine at 3/4", top and bottom for both sides. I've been tweaking out lately, worried about the frame bending and was happy to measure it to be the same both top and bottom and side to side.

 

Driver side is spot on, passenger is a bit high. Something has been tweaked somewhere. I'm guessing it could be from when my truck picked a fight with a backhoe. Gap is 7/8" at the smallest. Can't wait to be done with this project. Just need to tie into the side supports and finish riveting.

 

What is that?

 

That's the custom reh5108 shock mount. Weld-on, with greaseable bushings.

 

AAAAAGH
Your truck is gorgeous. I wish I'd found a green one. I dig my gold w green cap two tone, but damn that green is my favorite taco color.

 

Welded? Looks like bubble gum.

 

Who designed this?

 

Oh my b, must be that new jb weld mouthmix^tm steel epoxy

 

Why not just do spot welds?

 

Pretty sure that would ruin the bed liner if not catch the hole thing on fire. If the bed liner wasn't there I'd definitely weld.

 

Finally finished fabricating and installing my transmission cooler