San Diego BS Thread.

it cost me $15 On Amazon showed up in 24 hours...buy one bro

 

yeah, so we can celebrate our freedom as we are restricted in our movements and gatherings!

 

Anyone here have a left handed drill bit/extractor set? God apparently hates me. It’s not seized, just in there pretty good and shallow enough that I couldn’t get a good grip with the vice grips.

 

Hey John, I can probably weld a bolt over it and turn it out, shoot me a text if I can help.

 

If you have a rotory you can cut a slit in the top and use a flathead. Have had to do that many times. Works like a charm.

 

Is anybody here familiar with zoning regulations in SD?

 

does anyone have, or know anyone with, a sheet metal brake? I need to make one bend. mild steel sheet 4" x 7" x .130 thick.

need to go from flat to as close to 57 degrees (acute) as possible.

 

So do we need to make an active zombie map yet like the San Francisco's Poop maps? No reports of walking dead as of yet so I assume not.
And @cwadej I dont have a metal brake, but HF has some pretty inexpensive ones there that will do that no problem. I just use my aluminum welding table and clamp it down to a flat piece of steel and hammer the edge after a bit of heat has been applied.
I have a tube bender but thats obviously not gonna help for what you need...

 

they look stupid on any truck other than a raptor.

 

yeah, i just dont want to buy a cheap brake for a single small item, and i dont really have room for it here anyway.

 

The best mod!

 

Cuts down on reg fee right?

Edit: THIS is the best mod, half the cost and no smog

 

Must be nice...

I used to have a Ram registered in AZ and my Jeep in CA because I didn’t want to pay the fees here. My Jeep died and I traded the Ram for my Tacoma and the address I used in AZ I could no longer use (ex-bf) so I had to suck it up. Sucks.

 

Yeah I bought some lands out there mostly for registration purposes, well worth it in my opinion!

 

If you put a shell on it I believe you can get it classified as non-commercial which should lower the reg fees.

 

I might go to HF in the next few days and I possibly pick one up, I always need more tools, if so I'd be more than happy to bend that for you, that is if you haven't done it by then.

 

Hey any you guys use an OBD Scanner app? I started playing with Car Scanner and it's pulling a C0100 and P0152 code...One of these is an Bank2 sensor one high voltage...A little concerned to this at 5k miles though.

However....the OBD Link app included with the dongle, is not pulling any code and no CEL..

 

thanks. I've actually decided to go a different way. new design takes out 3 parts so hopefully will be sturdier.

i appreciate it though.

 

anyone know where (in san diego) i can take my kayak out that isn't the ocean or crowded beaches?