What Have You Done To Your 3rd Gen Today?

crappy photos.

 

Looks great! Looking to get that roof rack myself. How is the wind noise from it? Bearable?

 

My 2019 SR does not have Interior climate controls but it has the vent as he called it. Still think it is the collision audible warning. It sounded like it was coming from that area when a guy decided to turn in front of me without using his turn signal. The alarm gets your attention for sure.

 

Hauled a couple loads of boxes today helping my pops decluter the house before I buy the place and got a nice pic next to his 07 TRD OR with a 6in lift and 35s and picked up my weather tech rain guards for install tomorrow from a local shop I’m friends with and got it tax free for paying with some cash

 

Not for my 3rd gen.. but Built/shipped this out to @KnckleChldrn .


check out my thread
https://www.tacomaworld.com/threads/socal-switch-pros-installs.656005/

 

It could be. But the beep still sounds it’s coming from deep in the left side of the dash behind the cluster.

 

noise is there but completely bearable in my opinion.

 

The Fire Extinguisher is from Ace Hardware.

https://www.acehardware.com/departments/hardware/fire-safety/fire-extinguishers/8035925

If you get this, use one of vertically lined up holes and the top of the bracket matches the height of the molle panel. Use one of the 10-24 bolts ( I used 1 1/4" ) and a wing nut and it'll be very secure at the top. The bottom hole won't line up with anything, so you'll need to drill a new hole in the molle panel or zip tie it down nice and tight like I did. If you want a photo let me know and I can post one.

A few lessons learned on installing the molle panel...

1) Secure the two halves together first, then put the rubber spacers on. If you follow some videos and put the rubber spacers on first, you'll end up realizing you can't secure the two halves correctly with the rubber spacers in the way.

2) The galvanized(?) metal hook tie downs ( not the D rings ) near the front of the bed on both sides will need to come off.

3) Eventually, I'll either paint or plastidip all of the silver hardware they provide to prevent them from rusting out as well as dipping the hole left over from pulling out the tie-downs.

Let me know if you have any other questions.

 

Your truck is so damn clean

 

Jealous !

 

Sliders.

 

What brand?

 

Finally got my grill put in

 

nope knew what they are just wanted to know the size. didn't know if he had 1.25", 1.5"... etc

 

Sooo, Lol. Got the last stubs welded for the roof rack, on the camper shell. Now gonna paint and skin it. Film at 11, in about a week. Lol
Zim

 

Y’all think these will fit under my taco? 17x9

 

A lot of factors play into that, but without knowing offset, I would assume a cmc would be needed at least.

You need to provide us with some info;
Do you know the bolt patter and offset of those wheels?
Do you have a lift? (Seen that you have 3” front and 2” rear spacer lift?)
Willing to do a cmc or currently have one?

That’s just the basic questions.

Edit; Easiest solution, ask the guy if he will let you test mount them and see what happens at full lock before ever even driving with them.

 

So that new Meguiar's ceramic wax is pretty legit. Claybar and two coats and this is the shiniest I've seen it.

 

New wheels, tires and leveling kit today. BF KO2s 275/70/17 and 2.25 leveling kit.

 

I just installed the same lift!!