265/70/r17 rubbing with spacers

Few more pictures of my setup

 

Nothing else besides my shell & OEM Front Skid. My shop said no problems with the lift & SPC UCAs. It's been great & I bought the Toytec Lift kit

Those are the Toytec 600 lbs eibachs. I went with BK0510 because its the & cause of the DC V6. It could be the front weight that is throwing everything off with the 600 lbs coils. You could probably buy the 620s & switch them out, but you might as well get 650/700 with the winch & bumper. That might be best with the

 

Thanks!

 

The JBA UCAs added at least 2° to your caster which pushes the wheel further forward. That’s definitely why you’re rubbing in the front. Trim the plastic and you’ll be fine.

 

Full tank of gas, don't drive much now . I measured on my truck; Front Driver side 23" - Front P side 22 7/8s -- Rear Driver side 22 3/4 - Rear P side 23 1/2. I do not have coilover but did get a bro lean plate. The difference there is your winch & bumper. I do have SPC though.

 

Thanks man! Deff need to get the next size up in springs.....looking now

 

This is a damn good snow taco, clean. The darkened skid plate fits nicely!

 

I'm not sure if eibach has 650s or anything higher then 620 that has toytec lifts stamp on it. If I need anything I normally call Hugo, he points me in the right direction.

Another side note, I didn't want 650 springs cause I dont have any armor & went for the 620 as a better place to start. 650/700 without armor/winch can be to stiff even coming from a sport suspension.

 

You running C load 265/70/17 BFGs? I've been thinking of going for Victory Blitz bumper but RCI is in Colorado. I'd save on shipping fees & probably not compatible. What bumper/winch is this?

 

Thanks. I try to take care of it. I always liked the TRD skid but didn't care for the gray color. Some Rustolem oil based flat black took care of that.

 

Yes C load tires. I dont have a need for E load. As for bumper its a C4 Fab low profile bumper. I like the look and adds a place for my winch. The winch is an X bull with synthetic line

 

Don't use spacers!

 

I got a quote from headstrong to get the ome 896 springs and nitro socks. Who's running this setup with the same size tires

 

Just start cutting until it stops rubbing.