What Have You Done To Your 2nd Gen Tacoma Today?

New Fogs. I really like the look of them.

 

the character would be fine but it needs to adjust a bit so the door will open lol

 

Installed my 100% custom fuse relay panel. Essentially the exact same thing as an Spod or Switchpro but it only cost me $100 to make. Relays are hidden under the panel I made

 

Mounted and wired the LED bar, now to wait for the license plate relocation bracket.

 

No idea how heavy my kayak is. Might be around 50 pounds. I have to turn my mirror when loading but, other than that I have really enjoyed it. Especially when I’m by myself and even more so after a long day paddling.

 

Cleaned her up a bit!

 

Was it a pain in the ass to mount behind there? Looks really good.

 

Got my front anytime camera mounted in the perfect spot at the underside of the top lip of my grill.

 

Did you drill into the grille surround to mount it?
I'm still waiting for the company to ship my kit out.

 

Drilled a small hole for the studded part of the camera to slide through, then notched the top metal of the grill from the backside so I could tighten the nut holding it in place. Just uploaded a vid showing the process.

 

Good to hear. Did you replace the stripping on the doors too?

 

Had my 235/85R16 Yokohama Geolandar AT's mounted.

 

That's super clean man! If you dont mind, can you show a pic of how you have the switches in the cab? I really would like to clean up all the wires under my hood from the ditch lights and light bar, and make it easier to add more lighting.

 

I like that Cali Led mount. It’s on my list...

 

That's what I have, was really easy and straight forward to install and located the bar perfectly.

 

No. Those are quiet as can be. It was just the surround that was noisy.

 

Finally got it paid off. Now the real fun begins with the modding...:toyota:

 

I didn’t use any mounts, mounts won’t work for me due to the body lift. Used 2” self-tapping screws and washers...it feels feels pretty solid, it’s not going anywhere.

 

Please excuse the dirty truck.

These are the switches I used: Nilight 90017C 3 Gang Aluminum...

$13 Nilight 90017C 3 Gang Aluminum Panel Toggle Dash 5 Pin On/Off Pre-Wired Rocker Switch Holder for Automotive Car Marine Boat, 2 Years Warranty,Blue

https://www.amazon.com/dp/B07TJQ7738?ref=ppx_pop_mob_ap_share

For the switches to the left of the steering wheel, I had to use a dremel to widen the holes for the switches to fit and I ditched the metal bracket they came with but used the same wiring.

This is the youtube video I followed for making the fuse panel: https://youtu.be/RY45UHCfeHk



Hope this helps. Feel free to PM me if you have any other questions

 

Thank you..it really ticks me to find a turtle some AH has run over, god knows they dart right out into traffic....I have helped a few across over the years...