Replacing the ECT button

I work on guns, not trucks so this is going to be an easy question for y'all...

I would like to replace the ECT PWR button with this https://www.aironboard.com/online/push-switch-961b-12volt-toyota-oem-replacement-power-blue.html

Is this a simple pull out the stock ECT PWR and plug the new one into the connector or more to it?

 

No it will not work for your application. You need a momentary switch for the ECT button. Look here:L https://www.aironboard.com/online/products/switches/toyota-push-switches.html?rockerswitch_type=12

 

The switch will fit in the hole on the dash panel, but the wiring connectors aren't the same. What are you trying to do exactly?

 

Well, since you said that, I'm on the market for a 308 with scope, don't need 200 yard+ range, just deer and hog hunting and an amateur aiming target fun. Any budget friendly options you would recommend?

 

Not too easy for me???????

 

Just want to get rid of the stock ECT PWR switch and put in one in that says "POWER" so my wife stops asking me what the ECT PWR does and make my truck look a whopping 5% cooler.

 

Can't go wrong with a standard Remington 700...don't buy all the fancy models, a $600 rifle will do you just fine.

 

perfect! Thank you good sir

 

Easier and more reliable to put a "POWER" decal over it.

 

That's a tough one. You might be able to pull the cover off of the AirOnBoard switch and pull the cover off of the ECT switch and swap them. That's an extreme long shot though. Good luck. I'm divorced so I understand the value of a happy wife.