Keystone State Thread

Good mornin' fellow Pennsyltuckians!

I'm going to be installing the factory bed step in my Tacoma this weekend. Should I go somewhere to use a lift or will jack stands be sufficient?



Pool is open....at least we can start to get the water cleaned up so that when we finally get some warm weather it will be ready.

Be safe out there!!

 

Morning folks. Listening to the weather report and they are calling for possible snow flurries this weekend . I'll believe it when I see it.
Beautiful day o tap for today so be Safe and be Well folks.

 

It’d be nice to have a lift in the garage

 

We are on tap for 3 to 5 inches of snow.

 

In case I do end up having to cut a bolt, you know what kind of bolts are holding them in? Thread pitch, size, etc?

 

Gonna try to get these in today, wish me luck

 

I only know the PN is 90080-10138 for the bolt and 90178-A0050 for the nut.

 

Alright, thanks. I’ll spray the shit out of it with PB Blaster

 

I think a 1/2" grade 8 of whatever size will work, just check to see what fits through your bushings tight.

 

Not sure if joking...

 

Although it's not Friday.......... I am joking.

 

Anyone know a fabrication shop or fabricator that can make a pre runner tube bumper ? I’m In montco, Delco, Philly area

 

@Arcticelf perhaps!

 

yes probably @AtticShelf

 

Have a picture of you want? I've done a couple bumpers.

 

yes sir. I dm’d u on Instagram

 

Since I’m not too familiar with loctite and anti-seize, what should I and what shouldn’t I put loctite and anti-seize on when I put these leaf packs in? I almost have the passenger side out, just gotta take the U-bolts off and slide it out

 

I use the P2 on my other truck and highly recommend it. It's never let us down. P3 is supposed to be about the same. I don't think you can go wrong either way.

Where do you plan to install it? I will probably install on in the Taco in the cubby to the left of the steering wheel at some point, but try to keep the heavy loads for the F250.

Don

-

 

Only took me 3 hours to get 1 out

 

WHAT!!!