Norcal Spotted and BS Thread

Thanks bro! Thats great too!

Stats. I honestly think that our professor wont even look at it. Lol. He hasnt graded anything all year and ensured the entire class will pass

Cited bro! Lol

 

I do hope you're kidding about the citing though haha

 

In comparing the violent crime rate to determine whether the rate was higher or lower during CY2000 or CY2010, I determined the rate was lower in CY 2010.


CY == Calendar Year. Use FY if the years are fiscal years.

You're welcome.

 

Hello all,

Been a bit since I’ve been on TW. Hope all of you have been healthy and enjoying plenty of cold ones.

going to do LBJs, ITRE, OTRE, steering rack bushings and replace a blown CV axle shaft.

my question is regarding my coil overs, installed about 1500 miles ago, about 100 or so on trails/washboard. Seems they have settled about a 1/4 - 1/2 inch from my initial measurement. I am going to be getting the front end aligned after the install of the parts mentioned above. Would it be wise to adjust my coil overs up a bit more 1/4 in. CV getting replaced has over 120k on it.

 

Lol... Damm bro. What do you think of me

Oooh. That's good! Thank you sir. I like that one

 

Now if your instructor is hip; you might try: Man, I looked at 2000 and 2010 and those mother fuckers were violent in 2000!

 

Aye Prof,

Check this out yo:

 

Hes a rainbow canadian...... Idk man...lol

 

Never thought it would be kinda sad to see a porta shitter go away.
We've had the same one since the fire and finally it's gone.
Like loosing an old friend.

 

Legit!

 

I appreciate the advice. Another 1/4 in would put me at a 2-1/4 in lift over stock with the way it sits at the moment. Going to give it a shot and check CV angles and see how the front end feels. Then again, I am no suspension expert either

 

That sounds reasonable. If it ends up being too much you can always take it out.
Also I wonder how much effect preload has on alignment.

 

So, like thisonetimeinbandcampInoticed, like, there were sooooo many people who like were SOOOO violent in 2000! ThankGod, 2010 was somuchnicer! Eh?

 

@Pella and I made some progress on the bumper/swing out remodel project.




And... I spy another 4Runner in my driveway...

Another Timing Belt/Water Pump job on tap for tomorrow.

When did I start posting in T4R.org???

 

Oooo ooo ooo

The brown truck driver just made a late delivery

 

Nailed it.

Also...fuck these damn delays!!! I need a tent!!! And my sons fucken bday present that was gonna arrive mid april. Gahhhh!

 

Ya, she really wanted to say hi to the guy in the brown shorts.

 

Why does it look like there are hinges on both sides, but no gate in the middle? Not completed?

 

The passenger side will have hitch pins instead of bolts. The bolts on all four was to fab and keep everything aligned.

 

Braking in new diffs gets boring