Tacos in St. Louis area

That was impressive. Now a single shot of the grouted floor! I’ll come back and remove “haze”.

 

Got the legs and mounting plates welded up in my sliders. Need to clean them up and paint tomorrow then they get welded to the truck. I welded the legs at about 18 degrees because I like it angled but I want some room between the door and the slider. 18 leaves about an inch between the kickout and the door.

 

That’s what I did too, works well! Looking good man

 

.

 

Got the ECGS diffs in and installed the rear. Wired up the locker. Next weekend the front will go in and I'll be ready to test off-road. So glad GT talked me into getting the Harrop over the ARB.

 

@CygnusX191 this seems like something you should see.

 

What a filthy, dirty, beat up, piece of junk.... It's glorious

Man if it was an ExCab I know what I would be doing this weekend....

 

@TacomaDad18 @Cav_BluTRD @Sasquatch3153 and I are headed out to Pruitt Mountain adventures again tomorrow if anyone wants to join in. I just got my sliders done so I have to give them a test run.

 

Time?

 

9:00 ish? Not very planned out just figured I’d throw it in here. Rich and Jason are camping I will probably leave early to fish in a lake there but we can link up once we are there I’m sure.
@CygnusX191

 

Don't know if I'll make it. Damn. Need to plan out ahead a wee bit lol. I do want/need to get out there.... Also need to swap shocks

 

If you dont have suspension by the time I get mine I'll give you one HELL of a deal

 

I've got rear shocks and front coilovers from an OR truck. Should make the ride less jarring on the rocks. It'll hold until I get a real suspension.

 

Replacing a starter in a 3rd gen via factory recommendation = taking half the truck apart.

OR

We could do it THIS way

 

That looks like a huge pain in the ass to replace either way

 

It is. Probably gonna have to remove the cat anyway even though he says you can get it done while leaving it on.

 

I tried lol

 

oh do hit me up when you do swap out suspensions. The shocks I have provide zero lift.