1st Gen Lunchtable Thread - General Discussion

hairy or not

 

I don't give a fuck

 

Uh.. I’m not camping with you! Lol

 

Got to work on the hundy this afternoon.

After pulling the alternator, I had a mess with oil and grit soaked wiring harnesses.




Took the old wiring apart and cleaned it.




It wouldn't take much for the wires to start breaking down after running in the grit.




Cleaned the wires and wrapped in F4 Silicone Tape. Then put the wrapped wires in flex conduit and wrapped it again.

All wires will have a double layer of F4 Silicone Tape

The idea is to have a wiring harness that is airtight, waterproof, and oil proof.




Double wrapped alternator and O2 sensor wiring harness.





Took the newly rebuilt Denso 100a alternator from Rock Auto apart to check out the brushes.

I ordered a spare set of brushes to keep for when those wear down some years from now.

In case I need to swap brushes some weekend in the future, I don't want to playing a guessing game to figure out the correct type.




Brush protector guard and bumper.




Put it back together and did some polishing just for fun. I don't do it enough to get to be good at it.

I will spray it with a clear coat so the aluminum finish will be easy clean and to keep it from becoming ratty looking years from now.

 

Not doing the sequoia 150 amp swap?

 

Didn't know about it.. Oh well. Next time.

 

Eh. Your not running a ton of loads. 100 is fine. But yea, sequoia tow package alt from the later years of The 1st gens are 150
Tow package tundras are 130

 

https://www.youtube.com/watch?v=R8yLHer2S4M

 

You're not my type anyways

 

i'll take that as a complement

 

go suck a lolipop kid.

 

Oof

 

You're such a nerd

 

Out of the blue, I get a paycheck from my company after being laid off for almost three months.

Nice.

 

Why didn't you just rebuild it yourself?

Looks like they used the old stuff with new bearings and brushes anyway

If you can find a place local that supplies the rebuild parts theres a place local to me that has all the parts in stock 21 bucks to replace the brushes and voltage reg in my old camrys alt

I paid 60 some bucks for new bearings brushes, voltage reg, diodes, and stainless hex screws (he plays on the beach and it was crusty in there) on my buddies 4 runners alt

 

Bruh in SF that will get him 2 gas station hot dogs

 

Because sometimes it’s just worth it for a warranty.