BUYER BEWARE: 2nd & 3rd Gen Tacoma In-Cab 120vAC 400W Anytime Power Outlet

It has to Stew holes under led, then I flipped it over and put liquid electric tap around the plug to seal it.

 

What kit was this? I ordered an earlier one and would like what this one has included.

 

Here is everything I ordered. Got it all working last night with no issues.

https://www.ktjo4x4.com/product/toyota-oem-package-1-in-cab-ac-120v-400w-power-outlet/32?cs=true

https://www.sparksparts.com/oem-parts/toyota-power-outlet-8553035050c0

https://www.sparksparts.com/accesso...ed-dual-usb-powerport-00016-00225?parent=1325

https://www.sparksparts.com/oem-parts/toyota-bezel-power-outlet-8553635020

 

Thanks

 

Thanks @KTJO 4x4 for the harness and @kecknj for the clean OEM-like install inspiration! Top of the lower vent upper hole to the bottom of the bezel: 42mm.

 

That looks fantastic! Good job!

 

Has anyone installed Package #1 with the 85530-35050-C0 outlet on the back of the console WITHOUT the bezel? If you did, can you post up some pictures?

@KTJO 4x4 - if I mount the outlet to the outside of the console, will there be any wires showing inside the console?

David

 

You will not see wires on the interior of the middle console if you install it that way. I have not seen anyone install the plugs without the bezel though.

 

her you go bud

 

no wire show when installed ,there in the center counsel in the back walls of it.

 

Hey, @KTJO 4x4 I apologize if these questions were already asked.
With this mod, does the bed 120V outlet continue to work as normal? Can you use both in-cab and bed outlet at the same time?
Does the 400W OEM button engage the cab outlet as well (or do you need two buttons)? Will it now run 400W anytime (when not in Park)? To both outlets?

Thanks

 

Yes it works like normal and you can use both at same time , only need one button.

 

Looks like this is a ground from the diagram. KTJO harness. Any idea? The red wire.....

 

Yes. see below

​

 

Thanks! Wasn’t sure cause it won’t reach that location. I’ll have to extend it with some extra wire.

 

It looks like it should reach. You should be able to fit it between the ring connectors of the black wire and the two white wires.
ETA: BUT, only after you have the large white connector plugged into the inverter.

 

correct! It reached.
Now to figure out where to tap power for the USB’s and I’m done.

 

The red wire that is attached to the main harness is a ground wire. I attached mine to the nut on the side of the metal bracket that the inverter sits below. Here's a picture of the nut I used.

David