1st Gen Lunchtable Thread - General Discussion

Where’s the best place to buy a full carpet replacement?

 

I've seen a number of people reference ACC from Rockauto. IIRC @01x4 replaced his with ACC.

 

Havnet tried this in a few months. Think i did Okey enough to try and build something. Maybe a welding table

 

You've graduated to Pace Setter quality.

 

Woudlnt trust it on a gokart yet. But sometimes stationary sure

 

No better than Trail Gear either

 

Are you welding with gas? Cleaning the material with a flap disk?

 

No gas. Never got the fittings to set it up. And i did a quick clean on my belt sander. Im just down here to grab some stuff and was like hmm lets try a few passes before i leave

 

When you want a low rider but you gotta work for a living

 

I've seen bumpers and other fab work built with less quality.

 

It looks good on older trucks

 

I dont doubt it. Im sure their are tons of “pro welders” out there

 

I love putting a mouthy "welder" in their place.

 

Try less stickout if flux core perhaps the flux isnt shielding it right, clean the metal if dirty perhaps the burning impurities are creating that porosity

Also make sure youre running dcen if flux core or dcep if mig

 

2 trucks ive seen for sale had house carpet in them

 

Works both ways too. Ive seen some beautiful beads break on the hydraulic bender, and 10 mins later a less than stellar weld will hold up fine.

I always cringe when I see anyone stacking tacks with a mig gun and acting like their all that. Shit will fail the minute any pressure is applied to it. Sucks that I see it the most on here.

 

Doing car things for once

 

Looks like new

 

My grandma had 36 malicious chrome extensions installed. They were displaying pop ups over every page and even over other apps