tacoma lean

Okay so my truck leans to the drivers side, i thought it was my blown rear shock,no biggie and changed it.

But that was not it. upgraded them to kings and still have the lean, i took off my leafs measured them and laid them next to each other both had same flex/height etc.

any ideas or anyone with similar problem??

Ill try to get pictures .

 

Taco lean is well documented. Heavy crap is all on the driver's side. Can be remedied with a spacer shim on the driver's side strut assembly or by going to coilovers and adjusting the driver side slightly higher.

 

If you have a weaker FRONT spring that can affect your rear stance too. Eyeball the front and see if the passenger side front leans a little. Also did you take measurments from body to floor-AND is the fit/finish of your rear bumper-to-body right? Sometimes an illfitted rear bumper can make it look like a lean

 

gas, battery, driver are all on the left side. tis normal man

 

i have kings in the front maybe ill try cranking the coil a little .. but ill have to check the measurments from body to floor, and bumper is good.

 

a good fix is TSB spring and Firestone ride right air bags. I load my truck most weekends with 2 dirt bikes so the stock springs where worked. My s-10 also did the same thing before i put in new lift springs.

 

gangster lean.

 

not gangsta enough to pull it off. and i tried to get the TSB i was over on miles they said no. Guess 50 pack could fix this . hah

 

relocate battery

 

picccssss

 

Taco leaning like a cholo?

 

Date a fat chick, should level it out over time.

 

Haha!

only problem is that goes against my moto of "Lift it... Fat chicks can't jump"

 

Tried searching this and came up empty handed. Has anyone done this?

 

No offense guys but do you really think a 30lb battery is going to make any difference?

 

i dig my taco lean

 

You must be running a small battery, cause my factory battery probably weighs around 60 or 70 lbs.