What Have You Done To Your 2nd Gen Tacoma Today?

Having both air and battery I never touch the compressor except to fill tires and blow dust off things. My Porter cable and Milwaukee both rock.

 

I have always just used plain old wheel bearing grease and it’s always seemed to work just fine

 

nice s4 avant

 

Thanks ! Mobtown sliders . I think it’s a Rustoleum brand spray can bed liner

 

I’m on a roll! I did another thing, I got my brother in law’s left overs - a BPF Heavy Duty Tacoma Recovery Tow Hook - Heavy Duty Version.




I will NEVER get stuck on my Prerunner on those treacherous trails at the Mall parking lot between the Apple Store and the Cheesecake Factory.

I like it, just for show - and it was free, so, why not?

Rick

 

Finally found a color matched topper in the area yesterday and gave her a bath today!

 

Today I ordered one of those thingys. Lets see, hmmm. Oh yea a hc rear bumper from 4x Innovations. I have their sliders and have needed them. They did what they are supposed to do so I went for the bumper. 4-6 weeks out.

 

I thought they looked familiar. I run bolt on Mobtowns on mine. For as much Tacomas there are in Hawaii, I very, very rarely see anyone with real sliders here.
I was close to Line-X-ing them, but thinking about it now, I'm glad I didn't. I painted mines this time, but will probably look into a spray can bed liner next time. Do you put anti-skid tape on top after or has spray can bed liner been good at holding up?

 

It was an exciting day. First, I spooled out my winch line. Then, well, I ran it back in.

 

Installed new Cali Raised sliders today!

 

Swapped shifter balls from a TRD ball to a Hurst ball. The Hurst is a little smaller and my other trucks have a Hurst so it felt more natural. Hurst is Up for grabs if someones looking for one PM me.

 

You're cool, I think we could chill. Nice truck!

 

I like how the 20° sliders tuck up under the cab, looks good!

 

2nd gen 4x4 conversion?

 

Installed my BAMF light bar bracket today. Now just need to figure out how to wire the light bar..

 

Picked up a used bed mat cheap.
Hopefully no more sliding around and banging back there.

 

This is the first time I have done them . They were installed January 2019 ,I had them powder coated and welded on by a local shop but salty NY did a job on them after one winter . I’m going to get the anti skid tape tomorrow.

 

Finished taking apart my suspension and painting my gusseted spindles, and dropped my shocks and coilovers off for rebuild.

hopefully I can put it all back together Wednesday.

 

That looks killer, where is that first pic at??

 

who makes that rack?