1st Gen Lunchtable Thread - General Discussion

Sounds like a free wash and spotless dry to me

 

Any of you guys ever see a gap on SPC upper ball joint boots like this? Both sides seem to have it where the boot should meet the spindle.

 

Holy shit. The Aussies have all the fun.

 

Thanks for sharing

 

Yeah mine are like that

You can put grease in there to push the boot out but its just gonna splooge out

 

I put some in there a week or so ago and didn’t seem to lose any. I’m guessing as long as no grease is coming out it’s fine. Just seems like a piss poor design.

 

At the 24 minute mark is a blown LS Land Cruiser. @cruiserguy @Speedytech7

Edit: Actually it's a 502 big block.

 

@BartMaster1234 What you should have done with that Mercedes.

 

Yeah mine do that, it's normal as far as I'm concerned. Makes a mess after you grease them. Never had an issue from it besides the mess though

 

Now I know what to look forward to when I swap in the SPCs I've had for the last year.

 

I probably over grease mine, most people I've seen with them dont have as much coming out. I mean I grease them every 5k or so like they say to, and the old grease has to go somewhere so it comes out the bottom

 

Just get the baby grease guns and give them a shot or two. Should keep the mess small

 

My cat when pregnant kept jumping on the counter and hitting her belly, ignored the chair we put for her to jump on than the counter

One of the kittens looks to have broken legs

I tried

 

Damn that sucks

Help control the pet the population, have your pet spayed or neutered



RIP Bob

 

She was pregnant when she decided to not leave after i fed her, shes getting the snip snip

 

Sup bitch

 

Why you smelling it then

 

Kittens are assholes man, theres 6 tits on the mother and 3 kittens I have to sit here and cycle between the 3 cause they all pretend its pvp amongst their siblings for milk

 

I’ll keep an eye on them. Thanks guys. On a side note, apparently budget lower ball joints from rock auto don’t last very long.