NW WA Meet / BS Thread

I think those are reverse threads go for a jog backwards for a few miles and see if it tightens back down.

 

Does anyone in Kitsap county have a loading dock?

 

Does anyone know of a larger fold shovel that’s decent quality? I have a smaller one in my truck now that’s less than 2ft, works good but I’d like a larger one

 

Sure is quiet in the park today. Super nice down in Packwood. There is a cool brewery there, I recommend you all stop in if you're around

 

Per the wife... you should make an appointment. Its not uncommon for them to back out. Usually the bone is pushing the screw out. Easy enough to fix usually as they will just remove it. The "hole" will heal on its own

 

So that's what that noise was when I installed the 1" body lift on the bed this morning. Fuck.

 

Today a 1” body lift would have felt like a mile.

 

I did the cab last weekend and it's not that noticable buy my headache rack has an antenna plate that sticks forward over the cab and it was about peach fuzz away from touching the roof.

 

And I'm out. Just went through Roslyn headed to fortune cookie

 

like this?

 

I need a little assurance I’m thinking correctly. Pic one abandon the stock holder and keep my line below the reservoir minus the little kink I’m putting in it for the pic. I can manipulate the hard line a little to help it out. Or pic two use the stock hanger but have a little loop of line above it? It’s probably gonna be 1”-2” above it. I’m worried about trapping air.

 

id use the stock hangar personally.

i see now where it comes up. how hard was it to get the old line out of there?

 

Too hard of a bend on pic 1

air shouldn’t be a problem as long as you follow the bleeding procedures. Think of all the high spots you have in your brake system they don’t cause an issue

 

Yeah so can my rear driver door panel hahaha!

 

Pack it full of mud won't even see it

 

I’m not gonna lie, the old line came out in two pieces. I undid it off the surge tank bracket and cut it after the bend down by the firewall so it was somewhat straight. There’s a bolt holding a clamp in no mans land behind the between the fire wall and engine about halfway down that’s would be almost impossible to reach. After I cut it I yarded on it and it came out pretty easy.

 

Thats on my scouting list of places to go nice little spot on the river there.

 

ditto man....

 

Not as pretty as Goose Gear, but it cost $28 thanks to @bobsuruncle