What Have You Done To Your 3rd Gen Today?

It's about choice. Some people make bad choices. Alcohol is the same. I don't smoke and never have. I do drink occasionally but I do it because it tastes good and do not do in excess. Nothing like having a beer with friends sitting around the Taco discussing what the next mod will be. Today is puddle light wiring.

 

Was needing some bass after the kicker speaker upgrade. Wired a JL audio
Microsub+ right behind the rear passenger seat. Fits like a glove!

 

I’ve heard from a few they do fit, that’s my planned size when my stocks wear out

 

While you wont hear it too much, I would put that RCA cable away from the power and ground wires, being that close will cause a whine from the alternator. Its usually a higher pitched whine, so its filtered out with the subs crossover points, but there will still be some bad noises coming from the sub.

Just moving it a inch away will stop the wine. If you have the RCA and the power wire run both on the same side of the truck, you would have to redo the wiring and move the RCA to the other side of the truck, or at least far enough from the power wire.


But check to see if there is any alternator noise first before you go changing anything. Fold down the seat and sit back there, have someone else rev the engine while the volume is down or the music is paused.

 

Take those headrests out while you're at it. Lots more room for the dog and better visibility without them.

 

AUTMATCH D Ring Shackle 3/4" Shackles (2 Pack) 41887Ibs Break Strength with 7/8" Screw Pin and Shackle Isolator Washers

https://www.amazon.com/gp/product/B...&pf_rd_p=edaba0ee-c2fe-4124-9f5d-b31d6b1bfbee

 

My wife has a 2018 4Runner with the LED fog lights and LED DRL, we are trading the 4Runner for a 2020 Camry. I attempted to take the fog lights off and put on my 2019 TRD OR. There are 2 separate plugs for the lights on the LED fog lights. Any suggestions on what to do to swap the lights?

 

I think Toyota did away with the chrome after 2017. Shame on me for having an older vehicle.

 

Power wire and RCA are running on opposite sides of the truck but just feeding into that hole for connection to the sub. Ended up using some wire loom to isolate the power wires from the RCA as well. Never had any whine from the alternator tho!

 

Phase 2 complete. Heater control knobs changed out. Waiting for vent rings to come back out.

 

These came in today's mail - probably install tomorrow.

 

I missed your weight goal by 7.5lbs. With my choice:

 

Installed my Fox 2.0 rears and deaver aal this morning. Plan to do the fronts later this week. Also decided to paint the chrome on the mirror control knob.
Before and after. Gained nearly 2” in the back. Hopefully it settles around 1” eventually.

 

Nope, the silver fairy vomited all over my 2018 TOR

 

Perhaps it was after 2018 then. Like this?

 

Puzzle pieces starting to fall into place...

 

put it to work...

 

Finally put the C4 rock sliders! Had to prime and linex it before install, i think the truck is somewhat complete now!

 

In the best Tim Allen voice” UUEEGGHH”.

 

Please tell me there’s 4G there then I’m headed there. My wife and I have our house under contract to sell and both are currently working remote so we’re hitting the road!