What Have You Done To Your 3rd Gen Today?

So I upgraded the mirror housings with sequential flashers and replaced the mirrors with LED arrows in them with no issue. Then decided to replace the front signals with LED and everything appeared to work for a day. Then I started getting hyper flashing so I installed this resistor pack on the front LED flashers. Still getting hyper flashing. Anyone find a solution for this that does not involving replacing the front headlight assembly entirely?

 

I used goo gone automotive and it worked great

 

How you liking the hikaris after half a year?

 

Yeah buddy! It’s not strong signal by any means but I’ve managed some Skype calls and emails are fine for sure.
I have a little 4GLTE router that gives me WIFI at camp (similar to mobile hotspot on a cell phone) but this one has big antennas that pull service a little better.
Plug that into the Goal Zero Yeti and we’re in business.

 

Nice looking truck!

 

Are there any LED fog lights that can fit into the unused part of the TRD Pro fog light housing? Just curious.

 

I noticed that green ball near the driveway. Would you please move your truck out of the way so I can hit that green ball with my drive club.

 

Nice Z3!

 

Made a little sleeping platform with some closing storage underneath.

 

lighter fluid for the glue. Safe on paint and softens the adhesive. Let it soak and peel right off

 

Still love them. So much better than stock

 

Does the Trasharoo scratch your tailgate?

 

Installed the overlays after finding some alcohol prep pads at a grocery store. May ultimately delete the emblems entirely, but for now, this will do.

 

Hours later the sticker removal, residue clean up and re-installation of new stickers is complete.


Before



Gone



Replaced.

Week later report: I ended up with three small air bubbles, one bubble on each big letter on the drivers side. The bubbles were very small, 1/16" was the largest. Within 3 days two of them had vanished and the third one has almost disappeared, getting harder to even see it. The ARC, air release channels, really do work. No pin pricks needed.

 

Can you link the product you are talking about? I’m going to pick my first topper up in a few weeks. Would like to keep the paint in good condition.

 

Damn fairy!

 

This was my first trip with it so I can't comment on that yet. Is there a specific spot where you expect to see scratching?

 

Test fitted my center caps.

@MESO

 

Those are sure good looking. How much money did it cost?

 

Link where you got these? Do they have them for a trd sport?