Tacos in St. Louis area

Hey man I appreciate it. I no longer offer these because I am taking on a new venture in life. HOWEVER you can still buy them direct from ATS SPrings in Telford pa. They are all made right here in the USA and shipped to you tell them what you want to accomplish and they will build it. They have built enough of these now they can make custom packs in there sleep been doing it 30 years mostly for large equipment. Great people ask for Bobby

 

It's all good sir. Glad to hear from you and hear you're still going. Best of luck to you in your new venture.

 

Ok got my new hitch point, got it painted, breathlessly got under the truck to mount it. Original bolts too long , did not come with proper sized ones!

Do I start scowering hardware stores? Suggestions?

http://sosoffroadconcepts.com/factory-recovery-replacement/

 

2 days ago I noticed some specks of fluid on the bed rails and on the floor of the bed. Cleaned it out to see if it would come back. Checked again this evening and it's back. I'm assuming a small oil leak somewhere ??

Cant really see the backside of the motor because of the skids. Did check the rear axle and it looked fine. Any other spots to check ?

 

The underside of the bed and frame rails?

I’ve been sitting here trying to figure out how you have fluid inside the bed and on the tie down rails. My best guess was deer explosion remnants

Under your truck you should probably drop the skids

 

@ovrlndkull do you know what bolts off hand these should be?

 

I don't off the top of my head. TRD OR hooks are a lot thicker.

 

3rd gen and wanting someone to tune your truck?

want to tune but don’t want to spend $800?

need a TSB applied?

https://www.tacomaworld.com/threads/shellshocks-midwest-tuning-thread.672327/

 

Was literally composing a pm to send to you...

 

Yes the stock hook it's replacing is much thicker, so the stock bolts are too long. I could get them cut down, but worried there may not be enough thread left.



And oddly , they are a two tic mark head. I want to make sure I still get a replacement with a similar hardness.

 

My brothers an idiot, found some trail off of 141 and 364 last night. turns out it led to a swamp and instead of backing straight out, he tried turning around. Sunk his ass good hahaha just had to pull him out and I’m cursing myself, I always forget to take pics lol

The water was about midway up his tail lights.

 

Sounds like he was trying to 1 up @CygnusX191

 

Consider me 1 up'd

 

You just gonna let him 1 up you like that?!

 

If he wants to go snorkeling in his truck, I ain't gonna stop him.

Besides

I'm taking a tri-toon out tomorrow. Lake is like, 35 ft over it's banks.... We'll have fun yet

 

Don't let Chunk down, @CygnusX191