What have you done to your Tacoma today? 1st Gen Edition

What kind of hvac knobs are Those?

 

https://www.ebay.com/itm/183236629083

 

Thanks. Just ordered a set

 

You bet! If you have any questions shoot me a message

 

What trail was this?

 

Niagara Rim Trail. It's a really good shake down trail, with a wide variety of obstacles. It also has 2 spots that are pretty much freestyle (Lions Butt and the Rock Pile) where you can test your rig on harder obstacles... up to and including Fordyce/Dusy type boulders.

The trail is also nice because it has 4 different ways you can get in and out along the trail.

 

Looks like you guys had a good time out there. Jealous! Cannot wait to get mine out of the garage.

How'd the devil taco do? Run into any issues?

 

Can anyone confirm that this is the right part number for the harness side plug on the 4x4 position switch (transfer case, pass side top)? I have attached a picture of the switch side plug if that helps.

Plug part number - 90980–11156 (Detection SW (Transfer 4WD Position) (w/o 2–4 Select SW))

and does it take the usual terminal repair with wire (82998-12340) x2 ?

Here is the switch side plug picture:

@mechanicjon perhaps you'd know?

Thanks guys, just don't want to order the wrong plug and have to wait for the long delivery times again

 

ZERO issues. Sliders did their job.



Heard some pretty significant thumps on my skid plates, but they are 1/4 inch so I'm not even concerned enough to look.

I think the most significant issue that came up was I popped the fuse for my on board air, cause I wasn't letting it cool down... but I keep a full pack of spares in the truck. lol

 

About to get my windows tinted and I’m feeling some type of way without the cap on.




Edit: I started a poll thread for what looks best. Go vote.

 

For those with snorkels, did you need replacement clips for the liner and fender? If so where did you source those?

 

these what you're talking about?

$8 Rexka 25pcs Fender Liner Clips Screw Grommet Retainer Compatible with Toyota 90189-06214 Tacoma Tundra

https://www.amazon.com/Rexka-Fender...coma+fender+liner+clips&qid=1592856021&sr=8-3

 

Yeah, I just know some clips tend to break when you remove them, so I just wanted to see if I needed those.

 

Took the slug out again for me and the gf's 3 year anniversary trip

 

thanks, yeah it was difficult to find a nice fit this one is marked DEFLECTA SHIELD 502, i was considering cutting up an older lund visor fit for a ranger, but luckily found this thing and only had to mess with paint and wiring.

 

Tint is done!

 

Working on my front suspension. As long as I have the OME coilover for the drivers side on the drivers side is there any other orientation I need to be aware of on a 2003 Tacoma? Like the end of the spring at the bottom end facing inside or out?

 

Woah, your truck looks sick!

 

Have you thought about getting a matching Cabrac?

 

Mine look like this on my truck. Youre good.