What Have You Done To Your 3rd Gen Today?

It's an aluminum rack from SOS Offroad Concepts and a Smittybuilt basket. Details and more photos here: https://www.tacomaworld.com/threads/a-ridgeline-vs-my-tacoma.632662/page-9#post-21725940

The basket weighs more the the rack because it's steel.

 

I bet if you subdue the red (smoke it some) it may look better. Not sure how you would do that though.

 

Boruske Brothers
Dayton, Kentucky

 

Did something small!

 

Started putting together a charging station on the camper. Going to put in a inverter and solar monitor as well. Time and money, and I got the time. Lol
Zim

 

or that pesky bit of chrome top center of the windshield... can't STAND it

 

Sport hood installed!

 

I've replaced mine all ready.

 

Thanks - it's close to my place so I'll roll down there tomorrow

 

Was this hard to install?

 

Finished puddle light and footwell illumination on passenger side tonight. Also added a blue LED light in the door pockets.

 

Installed 255-75-17 duratracs today and finalized the anytime backup camera mod yesterday.

 

What brand Shackles are you going with? I just bought me this setup but Im having a hard time getting the right Shackle to fit

 

These didnt dit my demon ring. I think mine are uneven

 

Adjusted OEM fog lights I installed on my SR. Used scientific method, tools required:
1 - son with long arms to reach down and adjust lights from top
1 - garage door
1 - darkness
Steps: adjust until both fog lights provide even illumination on garage door, and slightly overlap the bottom of the low beam pattern. I have the full "measure this, measure that" instructions... meh. This will do for now.
Bonus- ordered some Hella H11 Xtreme Yellow bulbs for the fogs.

$23 HELLA H11 YL Twin Blister Xtreme Yellow Bulb (12V 55W), 2 Pack

https://www.amazon.com/gp/product/B079VYZ2TP/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1

 

i don't have that on my windshield, unless i'm looking in the wrong spot?

or what about all the chrome buttons on the headunit? i replaced the volume/tuning buttons with the RAV4 ones to get rid of some of the headunit chrome.

and then there's the sunvisor silver screws that need replacing too...

 

Nice!! How’s ya do it? Disassemble the wheel or just pull off the emblem?

 

I didn’t have to do anything really. It’s an overlay from @AJT DESIGN. It just goes right over the existing emblem. Super easy!

 

@LSUfan1975

I hate that they were closed. At least you know how to find it!

The wind wasn't blowing so the Whirligig park was disappointing too.