Hammer Hangers® by Archive Garage 2005-2023 Tacoma Shackle Hangers

Read the FIRST post...

https://www.tacomaworld.com/threads...-soa-sua-archive-garage.519625/#post-16458585

Does your caretaker have to make airplane noises when they spoon feed you? Because that would look dumb...

 

Waitng on my HHs, Towers and flip kit like...

 

No, it will be very close to stock height, you might see 1/4" lift with stock springs as @EatSleepTacos said

 

same...

:twiddlingthumbs:

 

Just went back under for a re torque and had to show off an obligatory photo

Can't say enough about the improvement in ride, I know it has been discussed at length already but it really is crazy noticable

 

Thank you for emphasizing the improvement
It's hard to believe for a lot of people, and that Toyota would still be building Tacomas will those stock hangers now until the next gen

 

I drive pretty spirited and in addition to the soaking of bumps during cornering, this huge amount of rigidity in the rear over that flimsy sheet metal is felt in the driveline even....during shifting, especially when letting her sing...., etc

Keep in mind everyone that my Hammer Hangers went on AFTER several grand in suspension upgrades

 

Love to hear this. I can't wait to get my HH and install them!

 

Curious. Does this hangers affect the size tire we can carry under the truck? Currently running a 265/75-16 but about to stuff a 255/85-16

 

What tire size you running and up under your truck?

 

nope, the spare will contact the diff housing not the hangers. This would only be a problem if you used the cross bar which does prevent any spare from being carried under the bed in the stock location.

 

and just like that i pulled the trigger

 

Shouldn't, hangers mount on the outside of the frame and spare tire is on the inside.

 

To add to other replies, there's still a little over ~33.5" between the hangers, so that would be the limit, will fit 32.8" tires 255/85-16 or 255/80-17 or 285/75-16...etc.

Doubtful on 285/75-17

 

Hey just wondering if I could get an update on my order. I think the order number is R947824749

Thanks!

 

My order took about six weeks.

 

Best bet is to send him an email. As a vendor, it’s impossible to keep track of every single thread and source of communication so it’s easy for a question like this to slip through the cracks.

 

First time stretching her legs with the 285/75/17
Currently running Dakar’s
Hammer Hangers are the way to go, specially with the shock relocation.

 

Got my hangers in the mail today they are ROCK SOLID. Excited to get my rear suspension set up with these- have a brand new set of Dakars ready to go on with them.

Tried checking out their website- do you guys know if there are any install directions online? I am pretty mechanically inclined, but definitely want to make sure these get put on properly.

 

Lots of tips throughout this thread, here's a recent one that's pretty thorough. Air hammer &/or ball joint press aren't necessary if you want to swing a sledge hammer at a center punch a few hundred times instead you WILL need something to grind/cut off the heads of the rivets though, there's not much of a way to do that without power tools.