1st Gen Lunchtable Thread - General Discussion

Been there done that. Learn some self control lol. I tried using 3/8 where 1/4 was needed

 

Lucky you broke the bolt and didn’t rip the aluminum threads out

 

A prerunner with a rear locker is very capable, but overall a 4x4 will work best, especially in things like mud.

 

Oof

 

Unlike tylers supercharger

 

I don’t have plans for off-roading in the truck but I know it will possibly happen since it is a Tacoma.....

 

You can wheel anything through anything if you dont car about it

 

Uh .....duh lol
I have better luck finding a prerunner locally than a 4wd. Not many Tacoma’s here as it is (1st gen). Plenty of 2nd and 3rd gen 2wds tho

 

Just convert it

 

Idc

 

I didn't own 1/4 drive until I was much older than you

Still, torque specs are spec

 

Just make sure if it says inlb your dont use a Ftlb

 

Choke up on your ratchet, snug plus 1/8 turn. It's steel going into aluminum, it's basically just a ground.

 

One must own every tool available......

 

Sat on the highway for a while waiting for FD to put out a jeep with angry eyes burning on the shoulder.

I found a 7/16" 3/8 drive socket on the shoulder while walking my pupper dogger

 

Riped into the 4.0 today mother fucken rats. Took about 6 hours not rushing. It's back together now and is running like a champ.

 

Rats!

 

Bourbon fills the cracks in the heart, right?

 

We're gonna need a lot of bourbon for this week