I shot my truck and now I have no cruise

I had an accidental firearm discharge inside of my 2011 Tacoma which put a hole through the passenger rear jump seat and in the cab corner interior sheet metal severing an airbag wire in the loom going to the side curtain system. I spliced the wire with a good solder joint and insulated the bare splice. I don’t have any airbag light before or after the shooting and repair other than the normal system test on startup but I cannot get the cruise to turn on, no on, set, nothing. All fuses are good. Any ideas other than another trip through firearm safety training? Thank you, Tom

 

Jesus. Glad your okay. Can't offer you any advice but I can offer you a roll of toilet paper.

 

LOL WHAT!!! *checks calendar, its not friday right?*

 

It's probably shot.

 

now I see who's hoarding TP

 

I don't have any suggestions for troubleshooting, but I respect you for owning the mistake.

 

Shoot it again

 

Last guy I knew with this problem had a hole in in hand and a bullet under his kneecap. You're doing well!

Have you had someone connect a scanner to it? I'd be curious if there was a code set or pending in there.

 

was it a glock ? i hear those things shoot all by themselves sometimes

 

NEGLIGENT ghost rider.

 

Replace everything where you find a hole.

 

Yeah Im thinking that's my next move, Thank you for your reply

 

Here's an install manual for a retro kit, I'd follow their troubleshooting section (pg 11) to start.
http://www.rostra.com/manuals/250-1836_Form5188F.pdf

Pretty sure this is going to end with you going through that full harness with a continuity tester.... tedious, but effective.

 

I don't mean to laugh, but