1st Gen Lunchtable Thread - General Discussion

Maybe dis?

 

Leaning heavily towards this one.

 

And it's ordered.

 

I hear ya man, it's a terrible website. Its just they're the only BL kits that I've heard nothing but good about.
So as long as the toytec kit is similar/same or well made and quality right sized stuff, it should be fine.

 

Saw some grease on my wheel the other day. Gonna have to check that out. Don’t know what from.

 

I like that one best too

 

Yeah, I've seen good reviews for 4crawler as well on the 4runner forums. Toytec kit is good, same materials, the UMHWwhatever stuff.

 

I would say it's your CV Axle, but you're 2WD. Check your ball joints, driveshaft, etc.

 

If it's grease it's probably a torn UBJ or LBJ boot, or the outer tie rod.

If it's oil/fluid I'd be looking carefully at those brake lines

 

But it might be the rear wheel. What then?

 

good point I was just going off of Barts post about the cv axle lol. Rear wheel + grease...driveshaft maybe? When my slip yoke was over greased it flung that shit everywhere. If oil then maybe the rear axle seal

 

Starts good and fast, if its the plugs then a code would be multiple cylinder missfires versus #3 again right?

 

Yezzir, slow but easy to work on. And no timing belt to change

 

Of the coils?

 

Hrm, shit's gunna get interesting as I do suspension and bigger tires on the 4runner. If I put the RTT on the roof now, it's already at almost 7 foot and the garage opening in only 7 foot. This might force me to either air down in the garage or get a small trailer for camping. Or get an air suspension that I can raise/lower when needed.

Need a new roof rack first, the factory one isn't up to holding an RTT and an aftermarket one should sit a little closer to the roof I think. Probably go with a Sherpa Princeton - https://sherpaequipmentco.com/shop/princeton

 

10 foot garage door

 

I have an old ass wooden garage door that's 7 foot tall. I keep thinking about cutting the opening bigger for a taller door

 

I wish. I can open the current opening up to 8 foot. Still a shit ton of work tho.