What Have You Done To Your 3rd Gen Today?

2019 Toyota Tacoma ReadyLift 3 Inch Front & 2 Inch Rear SST Lift Kit - 69-5531 and was installed by Duggy's Garage

 

IRC those lower ball joint bracket spacers are installed incorrectly.

 

Looks like you stopped another brake failure. Is that bare wire peeking through in that small indention? Or just a bad angle? Either way, Overland should correct their design flaw.

 

I'm not the the creator. Here's the link to the file: https://www.myminifactory.com/object/3d-print-toyota-tacoma-glove-box-drawers-105766

 

https://www.youtube.com/watch?v=JWC_gFG4t3c&feature=youtu.be

 

Ahh miss KTJO.
Just think she took on more than she can handle (Pre-orders, etc.).

 

Ya gotta admire her for doing what she does.

 

Thx for the info. At that price I think I will go with my own solution which might cost $20/ door and a bit of time to build my own wire harness tap.

 

Yup, her powerfolding mirrors are great!
First time dealing with some crazy wiring and near non-existant manual.
Was a great investment, but the initial down payment, projections, delays and the feeling that it might not work out, did make me second guess sometimes.

Lots of great ideas though. Looking forward to once she completes that A Pillar Grab Handle. I just can't do that initial investment anymore.

 

Well good catch. Didnt see that until you mentioned it. The bracket was sitting on that wire for few months so it might be bare wire. Ill have to patch that up.

 

Yeah, that's what I think too, maybe some more stuff I don't know about according to green room banned members thread

 

Since I buy almost all used guns, if she asks me if that's a new gun, I can truthfully say "No, it's old."

 

Wouldn't it be cheaper to go for KTJO's solution?
It is $67 for all 4 doors.

Comes with replacement LED injection molded trim pieces and pre made PnP wiring harness so you wouldn't have to tap.

Per door that would be around $16.

 

Did my question annoy? Why the bold lettering? I asked price and installer, I saw what lift it was in your post.

 

it's how was done on the website where i cut and paste those letters
for the price was $999+tax ,Duggys garage was $650 install and alignment

 

https://www.vleds.com/7443-50-hv-amber.html

Same as the type MESO uses in his Total Tail conversion kit. I run them and they are bright and look great.

 

Awesome I had seen these but wasn’t sure if they were too bright since vleds are known to be as bright as the sun I didn’t wanna be the a-hole that blinds other drivers.

I shouldn’t need resistors for these right?

 

Link to Hikari low beams?

 

Truck looks really good with those headlights! Quick review after a week or so installed? How was the install? If you used a Youtube video for the install, do you have a link? Thanks!

 

This one was pretty good

https://www.youtube.com/watch?v=bhGlwKRlAYE&list=WL&index=41&t=558s

Edit: Super helpful to release the fender clips from the engine bay side instead of yanking them from the outside