What Have You Done To Your 2nd Gen Tacoma Today?

Much appreciated!

 

classic. You made one of the greatest blunders of the world, first never get in a land war in Asian, the second is never trust a recruiter....

 

How did I not think of this? I've been looking for a location for mine.

 

How do you to grease that joint? Is there room when you turn the wheel?

 

I was going to say the same thing, looks like it might be upside down.

 

Amazon trd

 

Hm, it doesn’t look upside down. It just looks awkward lol

 

lucky find. I looked awhile for a black cap but never found one. So had to get a silver one and paint match it

 

I just happened upon this one on Marketplace. The ad description wasn’t great, so I sent a msg and asked for better details. No where in the ad did it mention it was for a Tacoma, so it likely flew under the radar of all us shell hunters.

 

Made it to the top of WV.

 

Isn't that what all those moly panels in your bed are for? Just my opinion but that doesn't look up to your standards with hose clamps holding it on

 

Finally uploading pics from my exhaust reroute, new thrush muffler for that growl, and exhaust dump just after the axle

 

Unboxed the shackles I ordered off Amazon. Got them in green to go.with the theme of my Spruce Mica build "Bruce"

 

Picked up the truck from the body shop after a deer incident. Did the Matt Gecko LED in the bed. Attached to the shell. Super easy. Very bright. Love it already! Used velcro which works great. @mattgecko

 

I forgot about this thread for a while but I've done a lot of things lately... Today I did a hand wash, rotated my tires, and then went and got an alignment.

Recently though, I added some Baja XL80s and some new cracks and scratches in my bumper lol. And some rotos on the roof.

 

No, drove 30 minutes to TJ and then flew the rest of the way.

Re your username/my dad's car.

 

I would think a nice bedside mount toward the rear of the truck would be more beneficial

 

Installed the OME FK29 carrier bearing drop (8mm) - I noticed a slight vibe between 5 and 10mph since installing the General Springs HD leafs. It's so slight that I didn't want to spend the time and energy installing and messing with angled shims, so I got the carrier bearing drop instead. Installed in three minutes, took the truck out for a drive, it's definitely lessened it to almost nil. It also lessened drivetrain vibes in other speeds that I didn't even notice I had. They're not momentary vibes, it was just the way the truck felt at any speed, with the carrier bearing drop there's less vibration. Definitely a noticeable improvement and basically makes it feel like it did on the TSB leafs again. It's a $20 win for me.

I also almost got merged into on my bike when running to get lunch. Thankfully I run a gopro for dash cam stuff, so of course it's on youtube. Always fun.

 

what was the reason to reroute that drivers side tube like you did?

 

I actually had the fire extinguisher mounted on a molle panel but wanted to move it to free up space to mount my fullsize spare vertically on the back panel against the cab. Given where I have everything else mounted on the molle panels I didn't have space for the fire extinguisher.