What Have You Done To Your 3rd Gen Today?

I'm a fan of the ChrisFix YouTube vids. Here's one on cleaning your engine bay that's at least worth a watch:

 

A couple weeks ago I almost picked up the same liners. Which version did you go with?

 

I like these more than the predator steps that came on my truck. I've been watching CL for a set but none have popped up.

 

Is that up near Linn Run state park? Site 2?

 

No I didn’t, but it’s funny you ask. I did try wrapping the emblem in Vivid light smoke tail light vinyl but I didn’t like the look.

Here’s a pic I took before painting the grille, looked at it again after it was painted and still didn’t like it so I pulled the vinyl off.

 

It can leak but you need to seal the holes and put weatherstrip around the bed rail for the cover. So you won't have leaks again.

I had that problem in my topper so I had it sealed up.

 

Morimoto xb

 

Swapped amp.

 

Since I have the low pro bumper, I did the all stock options and the new hardware kit is a must. I tore up many of the original ones, as it was difficult to get behind most of them to access the mounting tabs when removing the stock guards. It doesn’t come with any pre-drilled mounting holes, there in a very large lead time, and little communication form the seller. Overall tho, I am happy with them. Don’t know if they would wear well when you go with 35s. My 33’s still touch at full bump in a few spots.

 

New driver side cv and cleaned up my adjustable endlinks.

 

35’s are not coming for a while even if they do lol. So where your 33’s rub is it because the liner sags down a little?

 

Got rid of the stock chrome tails and replaced with Pro's. Gave them a coat of sealant before the install. After always having time to detail everyone else's car/truck figured it was time to do mine. Pro grill and Black Rhino Rims w/KO'2s are next.

 

It lays flat across the where the pitnch weld is, even though I hammered the rest of it flat, that is the low point towards the rear of the wheel well, because it is not formed and lays flat across it has the potential to rub there. You’d have to completely stuff the tire, with the super bumps, I only got there because I had the coil overs out and was clearancing the tires. I’m out now testing to see if there are any rub points

 

Got it. So not somewhere that should be a issue. Nice day to be out, be safe

 

prinsu install later today..
ordered some stuff from tnuts/Carr
Thule J bars clamp rather well, but will use a 1/4" piece of rubber so plastic isn't stressed against rail edges.

I love this rack.
yeah, I know.
throw me a bone, here..my money tree hasn't sprouted

also drawing up some brackets, and looking for a metal guy.

 

Can anyone refer me to led load resistor installation for 2020 tacoma.

 

What are you installing?
I just replaced my tail light and front signals with LED bulbs. I did install land resistors on all 4x signals to address the hyper flashing.

 

Just picked up a 3rd gen a month or two ago upgraded from the second. Slapped a lift and some wheels/tires on it. Feeling less of a grandpa now.

 

Primed and painted tow hook

 

Installed the new PRP seat covers yesterday. Took my wife and me about two and a half hours. I pulled the front seats and rear benches to make it a little easier. We're really happy with the colors we picked, as well as the fit. 24 hours in the truck, in the heat, and a lot of the wrinkles have smoothed out. After a week or so, we'll see if they need any adjustment. We travel a lot in the truck with our dogs, so there will be great when it comes to cleaning up dog hair.