Bumper Bolts part number please

I've searched everywhere. I've looked at exploded parts diagrams...I ordered 4 bolts that I THOUGHT were correct that werent.

Can anyone help me out with a part number for the 4 front bumper mounting bolts for an 01-04. The bolts that go into the combo body mount and bumper mount on the frame.

Thanks in advance

 

bump. anyone?

 

whats your email ill send you my parts diagram pm me!

 

I don't understand why you think you must go private with this. Why not just post the parts diagram here for the rest of us????????????

 

If you're talking about the rear i believe it's 12mm x 1.25
https://www.tacomaworld.com/threads/rear-bumper-bolt-sizes.275707/#post-6823420

 

This isn't the info, but it helped me. I brought the bolt with me to size up at Ace hardware. Had the pick of bolts at that point too.

 

I took the bolt to Home Depot. Looks like it's a m10 1.25. I'll be able to double check it tomorrow and update everyone

 

Looking for this also. Was it an m10x1.25?

 

Where are you located. I have a set u can have

 

I recommend use JIS hardware, so you can use the same size socket on them as the factory bolts. You are not going to find JIS spec hardware locally, have to order it online.

https://www.google.com/search?q=m10...57j69i60l3.10439j0j7&sourceid=chrome&ie=UTF-8

 

I'm located about halfway between San Jose and Santa Cruz. But, I don't need them, see below.

Thanks for the link and size...m10x1.25

I don't need the bolts...well I do need some but not to replace the ones I have. I need the nuts.

My frame end caps have broken free of the frame from winching a big ass tree off a road. I knew it was going to happen eventually.
I'm replacing the frame end caps with 1/4 steel plate. I'm going to need to weld in new captured nuts.
I'll need some sacrificial bolts to hold the nuts in place when I weld them.
But, I'll stick with the bolts that came with my ARB bumper.

Thanks for the help!
As usual TW doesn't disappoint.

 

As a side-
Getting ready to replace my front bumper assembly (going with stock)
What would be the the hardware/fasteners to have in hand? Expecting a few to break, plus I like to replace fasteners when its an 03 just for added longevity.

Appears its the 4 bolts holding bumper on -m10 x1.25 -but length? And then clips?

perhaps someone may have part numbers handy TIA

 

Was doing some research for this...In the event anyone comes across this thread and could benefit from the diagrams with parts, here are the pics.

 

Just go to your local hardware store and get some bolts. Ace hardware usually has a pretty good selection of grade 10.9 metric bolts.

No need for tracking down OEM part numbers for some bolts.