What Have You Done To Your 2nd Gen Tacoma Today?

@Joker56ace yours is the 2011 grille? What kit did you happen to use ?

 

New Paint Job!

 

Yes honeycomb grill , ebay raptor lights for newer pro grill

 

https://extrudedsolutions.com/TailgateSeal.html

The sides are the ultimate tailgate seal and the tailgate gap cover is the rok block seal. I ordered both on Amazon.

Eta- the ultimate tailgate seal can also be used at the bottom of the bed to seal that part of the tailgate but I chose to use the other product to keep stuff from falling between the two.

 

I saw that! I am going to order some for my next wax job. Any why is Amazon all of the sudden sold out?!? come on you all. LoL

Not that this pertains to you. I am valving my spigot, that I just added by my diveway, for Cold Hard, Cold Soft, and Hot Soft water. Parts should be here by the 29th to complete the project. Hopefully I can get this wax by the 29th too. Stoked for my first Hot Soft water wash and wax job!!

 

Gotcha. Any chance u could show a pic of what u snipped? How did u tie them in? Can’t decide if I would want to tap into the lights or do a separate switch

 

Tapped into the drl with a wire tap

 

My brother said that he saw that Walmart now also carries Chemical Guys products at least out here in CA.

 

I did too. Had to use wax remover, was kind of a pain.

 

Looks like a great idea but I was wondering how this would allow any rain or car wash water in the bed to drain? My bed is open but I do occasional brush hauling and it would sure be nice not to have to dig out all the twigs and leaves from the tailgate gap. However I wouldn't want a bath tub...

 

Waiting on a couple things from the dealer for the rest of the parts.

These bearings were under 2 bills with their bucket sale at Napaonline.com ordered online, picked up and paid for at the store.

 

Somewhere on either the face or the back is a number molded into it. Take that number to the dealer and you should be able to get a repair wire.

That number is crazy small. I use my phone and zoom in.

 

There are drain holes near the cab side of the bed. I actually widened mine up a bit since they can easily get clogged with leaves, pollen, etc.

 

There seems to be enough small drain holes/seams in the bed for any water that may get in to drain out. I have a cap so I’m 99% water free but I did think of what you said before I put this on. If the little bit of water that may get in doesn’t drain, I’ll remove it or figure something out.

 

I get the part number (terminal repair and connector) from TIS
It's how I'm installing navigation into my base model truck.

I also get terminals from https://www.easternbeaver.com/Main/Elec__Products/Connectors/connectors.html

 

holy crap that's a lot of connectors! Bookmarked for later reference.

 

Check out meguiars hybrid ceramic wax, I like it much more than chemical guys

 

Link for that shifter knob?

 

Right on!!

 

They sell it at Walmart I believe. Have only tried the spray and it’s great, but I have now ceramic coated the truck