Ontario BS Thread

Hey......fuck you.....







most likely will though lol

 

it maybe be in pieces, but you'll still out wheel evegeneyuy

 

eithwr way I can say that a vehicle that I had my hands in will finish the trail lol

 

i dont have 35s or any fucks. if my truck is fixed by that weekend from whatever i am gonna break in the next week and a half i am interested.

 

I Can give you a ride from brampton to sarnia worst case lol

 

We have brave soul here! Anyone else?

Bring the trailer, we can always load what's left for spare parts...

 

naa, sell it on kijiji.
$25,000 - only light trail use, no body damage, 200k km, no rust, i know what i got don't low ball me.

 

Replaced the Toyota breather today with

$19 Uni Filter UP-102 3/8" Clamp-On Breather

Uni Filter P/N UP-102, using an

Eldon James C6-5BN Automotive Black Nylon Reduction Coupler, 3/8" Hose Barb to 5/16" Hose Barb (Pack of 10)

Eldon James C6-5BN nylon coupler, for 2-way venting.
Before & After:

 

Is that better?

 

Some say it is. The Toyota breather is one-way, letting excess pressure out but not in. When the diff cools, it draws a vacuum - I notice this when I crack the fill plug to change diff oil. Presumably the vacuum can draw in water through the axle seals when off-road... or fording GTA underpasses after a storm.

 

I have always wondered about condensation in the tube. We have added more space for air to travel and the difference in temp from hot oil to cold water crossing mihgt do that.

 

Condensation isn't going to cause enough water to form in the axle to affect anything. Once the diff oil heats up again, the water will evaporate away. Remember most of the losses from flywheel hp to rwhp occur in the rear diff, some 11%. If you're hauling ass, 26hp or 19400W of heat is being dumped into the diff oil.

 

@Tridet167 have you done the smog pump filter relocate yet? That's probably the most popular application for the Uni Filter on '12-'15 2nd gens, though I believe a different size than what I used.

 

Yes i have.

 

What is the point of putting a filter on the smog pump? I’ve seen those a lot.

 

It replaces the pretend filter Toyota puts in there, a peice of foam. That eventually dries out, crumbles, gets sucked in and can cause damage.

Lots of guys just replace it before its an issue.

 

Ahh I should do that

 

Pretty sure it’s a 12-15 thing but I could be wrong

 

Here’s a little sneak peak of the 35/12.5r17 falken wildpeak m/t that I’m getting installed. Just picked 2 of the tires up for test fitting but let me tell you lots and lots of trimming had to be done and banging on the fire wall but they fit now with a small amount of rub at full stuff and fully turned but manageable. Getting a 1” body lift and 886 coils to replace the sagging 888coils And hopefully that eliminates all rubbing. 5.29 revolution gears getting installed as well. Follow on insta To stay tuned @orange_taco_adventures

 

Mine and yours both have the pump I think. It’s part of the system from that Valve that I had to change.