Sold- AllPro HD Sliders

My mistake on refinishing these AllPro HD sliders can save you on expensive sliders. I used a flap disk to remove sections of old bed liner to clean up rock chips and surface rust, unfortunately my impatience and lack of fully stripping them caused a terrible finish. They're great sliders if you're willing to take the time to fully strip them and redo. Or just install them on your truck and use them as intended. These are for a double cab short bed or access cab long bed.

Asking $300, all hardware included.

NO Shipping. No installation.

Located in Washington along I-5.

 

DCSB?

 

Location?

 

@WrecklessAbandon

 

Yes, or access cab long bed. Post updated.

 

Thurston county Washington

 

Yes

 

Sorry, that's a bit far for me, but somebody will get a good deal glws

 

Those look perfectly good for sliders to me. You'll sell them very quickly

 

Would this fit a third gen?

 

I think you'd need to do some minor modifications to the mounting plate to fit a 3rd gen. These where designed for 05-15 model years when purchased, the "new" Allpro sliders on their website say they fit 05-20 model years so I'm sure you can make these work.

 

Damn! I wish you were closer to AZ, so I could scoop these up. I've been looking for used sliders and skids!

 

I will probably screw things up if I tried to make any modifications. Wish you were closer so I could check. Glws.[/QUOTE]

 

another "wish it was closer", this is a steal! GLWS

 

I just bought a canopy today, or I would take these. Great deal. They look fine to me. Someone is gonna love these!

@TacoTim85 ?

 

PM inbound.

 

Same!

 

They still available?

I have a third-gen and I just looked on their website and it shows 2005-2020. So I am thinking they may fit. If they do, I would be interested. Do you know when these were manufactured?

 

They're currently pending sale for pickup tomorrow. I can keep you posted. They where manufactured before the 3rd gen came out. Looking at the current version on their website I'd say they'll fit fine with a couple trim outs added to the mounting plate.

 

Let me know if it falls through!