What have you done to your Tacoma today? 1st Gen Edition

The relentless gear is sweet. I say get it.

 

I plan on the predator front and wrap around back with the tire swing out carrier. I need to talk to them Monday to get further specs because I’m not sure how many Jerry cans the swing out can carry

 

it’s the one I used I just found it odd but didn’t know the reasoning behind the difference

 

Gave the ol girl a good wash.much needed

 

Well I was planning on having front brake lines all setup and ready for the front calipers. But dang it, the lines too short I got

 

Still getting use to this site but per this thread here is what I’ve done so far
Upgrades are rack and pinion, Front brakes, Driver side axle(CV boots were bad), Hvac servo, (switched to cooling manually as its summer and waiting on part $189.00). Led head lights, Leer top used, Wet Okole seat covers, Dash cover, Helo rims and BFG KO2’s 32”

 

Due to a leak, I replaced the two AC lines attached to the dryer. For one of the lines, the original part number has been replaced by one for a kit. Pretty straight forward except for a small plastic clip that seems to be to provide a gap to prevent damage by unintended contact between the lines.

However, no instructions so I am not sure where it actually goes. Need advice of an expert like @Empty_Lord



Due to only about 2mm clearance after install, I placed the plastic clip here. Doesn't seem like the correct spot, but neither did any other area I tried.

 

i've never seen this kit before

 

Ah, okay. It had a TSB AC007-97 (1995-1999, I believe) paper in the box, but I didn't try to look it up. Apparently there was an issue with that short line cracking.

No problem. It's gonna be fine the way I installed it. I was just curious if my guess was correct.

 

@Wsidr1

 

Thank you.

Man, I started to try inserting it where they describe, but I thought they would not risk someone damaging their condenser. Especially since there seems to be good STATIC clearance. They must be worried about movement due to harmonic vibration.

Thanks again.

 

any time! i still have to make a drive down to you to get those running boards.

 

Installed a Warn 2” front receiver mount for I can install my winch, which I will do tomorrow, now.....off to the car wash, truck got dirty went camping at Angeles National Forest on Saturday, great weekend

 

Makin last minute finishing touches, for our trip.



I'll carpet the platform tomorrow.

Double cab, back seat delete, mod

 

I underestimated an obstacle today and paid the price with my rear passenger cab body damage.

https://youtu.be/P2g3g_x6SKM

 

That thing is fuckin badass man

 

Curious: do you know much your awning weighs?

 

Finally painted and installed the center caps.

 

My 55" CVT awning weighs 21 lbs.

 

Thanks Mike.

is that a 270* one or just a straight awning?