NW WA Meet / BS Thread

Anyone here have a BFF Rear with swing out remember if this the spindle cap is treaded or just pushed on.

 

mine was threaded so I put a shop towel over it and used a pair of big channel locks to unscrew. Heated it with a heat gun first

 

Thanks! I started to hit it off then was like wait I think this was threaded lol.

 

I had the factory installed tow package cooler. I upgraded to a Hayden 677 ATF temps have been consistently lower. Could go up to the next size, but so far happy with the 677. Used existing bolts on the install.

 

this guy outta no where, but been a member since 2009.....

 

1st gen hotness.... with the Hayden 677

 

Haha yep I hit up TW every now an then.

 

bought a used honda mower tuesday on offer up.
upon cold startup no smoke, ran great, self propell worked fine. when i got home it fired right up, with lots of smoke..... ran it til the bag filled up and the kill switch quit....bag changed and now only second gear works.... get about half done and the rod starts to knock louder and louder. then it loses power and dies. dudes phone is off, account gone. i got fucked out of 260.00beware folks, i drew the short straw on this one.

 

Drive through a transfer station for weight. They can usually do an unofficial weight for free.

I ran those on my taco, then my dodge 3/4 ton came with them when I bought it. I was happy with them, but I never did any hardcore wheeling either. When I first had them installed on the taco, wifey said they weren't as loud as she was expecting. They did fine for me in the snow and ice over here in my neck of the woods. I was about to get a new set of them in 285/75/16 but they weren't available. Hankook now had a new design which is the replacement for them. It is the dynapro at2 I think. When looking at reviews, and tread pattern, I didn't feel it would perform like I wanted, or like the original so I opted for Cooper at3.

 

I would take it back to them this winter and throw it through their front window.

 

You didn't haul it with it on its side did you? Carb up? Or exhaust up?

 

met at fred meyer. have no clue where that bastard is.

 

nope. was careful to lower it flat out of the truck too.

 

Makes sense. Everyone who has done the 63 swap says the ride is way better too. I guess I'll start collecting parts for the 63 swap...

 

GCV160 motor? Are you sure it threw a rod? I have That motor in my mower and power washer and they’re basically indestructible. Pull it apart, spare parts are cheap on eBay

 

no. its an older one. it didnt throw a rod, just knocks alot. quit running. i just dont have time to mess with it.

 

which one would be the next size up?

 

678 they make several different sizes



tru-cool also has a good selection. https://www.trucool.com/products/tru-cool-lpd

 

Thanks! I think I'll buy the 678

 

You're just gonna one up a guy like that eh?


Have you read through this thread?

Or this thread?