1st Gen Lunchtable Thread - General Discussion

It's not me. Just pulled from the webz. You could just drop in a stainless insert inside the filter once you complete it with handle.

 

That’s not a bad idea.

ok great, I’ll take two.

 

Seen on Reddit:

 

Extra points for brazing

 

@Sperrunner can u show me what type of spring compressor to use on the 5 lug when putting new coils on?

 

I was unaware that I was owed extra points. It’s now been noted.

 

Torch

 

People underestimate the tensile strength of a good braze. I've only brazed with a torch, but at work we had a guy that could TIG braze like no ones bidness and it was often used for cast fixes and held up great.

 

I'm in love

 

It’s also not so bad working with a bronze puddle. Stuff just behaves.

 

Double uni-knot, only way to do it

 

*tight

 

https://youtu.be/jNiKU4-ybBc

 

I used this but cut the rods shorter to fit better

 

I cant even tie a normal knot

 

40s and tons. No lift

 

Thank you, im only doing the spacer and v6 coils not longer coils so shouldn't be too bad. Then get to see whats wrong with my slug after i get it aligned

 

was about to say well now i wanna see this done, but i think spoonman has pretty much done that

 

I'm at the doctor's office cause my leg is swollen and hasn't gone down. GF is worried that it's a blood clot. But I'm not experiencing pain, heart rate and blood pressure is solid. But playing it safe to ease her mind.