1st Gen Lunchtable Thread - General Discussion

9v should do it and yes

 

I am quite happy with my scangauge. It seems to do everything I need it for. But I've never used an ultragauge so I may not know what all I am missing.

 

I've had both.

Scangauge has a funky form and the display is very ugly. It does allow you to enter custom PIDs for manufacturer specific read outs.

The ultragauge is much more pleasing to look at

 

@what road you didn't tell us you bought a bike

https://v.redd.it/1emfc4xkz0h51

 

Isn't the UG the bigger one? I like the Scangauge because it's slimmer/smaller...I dunno I guess it's a to-each-their-own thing

 

Any help on the gasket for this plate?

It’s on top of the throttle body

 

I've seen to ultragauge display, and frankly, I don't find it to be all that attractive. But then, maybe it is an "eye of the beholder' type of thing.

@Yetimetchkangmi Ben, I don't believe you can really go wrong with either device now that an untragauge is capable of reading trans temps. That used to be the primary reason for choosing a scangauge, but that is no longer the case.

 

Lol i know better

 

What u gonna do now that u tried smaller?

 

Whatd they quote u for a 3rz out of curiosity? Thank you for the reference man

 

It’s too GD hot outside.

Figured it’s a good time to paint my chainsaw parts.

The Tacoma door lock actuator rods are very handy.

 

Somebody is selling this 80 in an FW yardsale group. No rust local car. Fuck me. I can't have any more cars. @Speedytech7 @cruiserguy

 

Whats the temp?

 

Car said 103. Heat wave here in the Bay Area for the next week or so.

 

Not bad.

 

I live in front of the Bay so I’m used to freezing and 60 degrees with a windchill haha.

 

weather.com says 109 here in Tucson. It's more like 110 I think.

 

Obligatory

 

Well I ghetto-measured the camber adjustment on my SPCs on both sides using the end of my finger... The left side with more negative camber on the printout has a very slight difference in the slot for the upper ball joint for camber adjustment. At least compared to other side.

I'm going to loosen that side and try to make it match the right side and see if that solves the issue.

 

I could go for some of that. Ive been dealing with high humidity and 90's all week. Hard to get anything done when its like that.