What Have You Done To Your 3rd Gen Today?

Took her out and hit some trails today. Got her a little dusty. Had a relaxing day.

 

New shoes and switched over to FJ steelies that I had powder coated. No more spacers, the offset is perfect for a 3rd gen taco

 

Looks awesome man! Got a pic from the front to get a look to see where they sit in the wheel well?

 

New knob

thank you @7r41lbr34k3r. Great craftsmanship. I’m happy I was able to snag one.

 

They sit just inside the fender line. I had stock sport rims with 1.25” spacers before to bring them out.

 

Looking good!

 

So the Pro tail lights are different and they’re blacked out???

OMG. I wish I could I un-hear that!

Where did ya get them?

 

Looks like you're sitting ~2" above stock? Get away without doing the CMC?

I'm up ~2" on 888 springs & considered spacers & 285s but not going that route if it also requires any nip/tucks since I'm not doing any serious off roading.

 

Tire carrier installed.

 

Did you get your lights installed?
I installed mine yesterday. This was a nice easy install. Love the lighting, another accent to go with the footwell lights and the cup holder lighting.
I installed the first light following the instruction. Didn’t like pulling the door panel loose, so I fished the wire from the door handle to the switch panel. I have some baling wire which is thin and it fished right through. This saved me from removing the 2 screws and pulling the door panel. Plus it saved a few minutes per door. I found the less I need to take apart the less chance of error on my part. Of all the installs I have done I must say this install was fun and relaxing.

 

Installed TRD grill badge and raptor lights.

 

Welcome to TW from a fellow Charlestonian. Born and raised.

 

On the advice of @Tombiology70 , I removed the bracket on the top front of the engine that supports some of the air components, lopped off the part that rubbs on the hose and abrasion sheath, ground it down and smoothed it out. Then rattle canned it black and installed. Now that hose won't prematurely wear or burst because of a poor engineering design.

 

Got the new Rigid Industries D-Series PRO Midnight Edition ditch lights and the pro grille installed.

 

Multiple reasons why all the shipments are being delayed. Production, package volume, staffing issues (drivers and hub/ramp employees) and so on. DHL stopped domestic deliveries a while back and went back to Int'l deliveries because they couldn't compete so they dont have the volume which helps with faster deliveries. We are all accustomed to getting things in a day or two which makes us impatient these days, me included. Hopefully things will be improving in the near future and those of us waiting for deliveries will receive them soon.

 

Looks sharp. He does great work. Love mine.

 

Arizona camping sounds like fun. Went to Sedona a couple of years ago. Beautiful area. Enjoy.

 

Sure is, the isn't easy stop around here. BTW - truck looks good

 

OK, 2020 OR 4x4 only 8 months old, why is water dripping from my AC area on the passenger side, inside? It is Texas but it is low humidity too. I have the things to do the AC drain mod but waiting for cooler temps to do it. is this an issue I may have missed on here?