Alabama thread!

Pier is closed again for repairs!

 

Have you went back and re-torqued all your bolts Phil? Especially your u-bolts, which should be re-torqued a few times after installation.

 

Boo!

 

Nope. I'm at 450 miles since. I was waiting on 500. I'll do them while I'm putting the cb in.

 

6 more mph and she's a cat 5. Looking like Hurricane Michael Devastation. We have designed and built 20+ Stacks in Port Arthur over the years. They will be tested to their max tonight for sure.

 

Evenin Phil

 

Just sitting at work. It's busy as fuck and I'm done with it

 

I’m sad for the people along the Texas and Louisiana coast but thankful my mom isnt gonna get hit by this monster in OrangeBeach.

 

Need some help. Does anyone know the size of the washer above the steering knuckle?


The UPS man delivered my jba ucas at 730 tonight. Couldn’t help myself, went ahead and installed both. I looked all in the box and it looks like jba didn't include them

 

Just measure the width of the bottom of the control arm and the bolt going through it.

 

Ok, I remember that. I had them with mine.

 

He said he needs help

 

Yes very sad. We have friends in Orange Beach and Mobile. Thankful for it not hitting our home state, sickened that it's hitting anywhere and will inevitably cost lives. Itching to go serve with our Church like we did for Hurricane Michael if needed. Hands and Feet.

 

He sent me a PM asking if I got new ones with my UCA's. I couldn't remember

 

Probably 9/16 that’s the bolt size through my uniballs looks like an extra thick washer though?

 

That’s what I tried to do. I found a washer that fits over the bolt portion but then it tapes out wider toward the top, it’s a weird size




See the threads end and then it’s bigger

 

I didn't install them in mine (haven't had an issue but may not be a good thing.) Where did you get that pic from???

 

I don't think I did either....a bit intoxicated to walk 2 flights of stairs. I'll check in the morning lol

 

Lol I guess I would be alright then. I think that pic is the third pic on google

 

That washer on the top there to me prevents the taper of the ball joint from fully seating into the spindle. I'm 99.99999999999999% sure that washer is 100% supposed to go on the other side under the nut that's how all that I know of are. I couldn't fit it due to my spindle gussets so I left it off.