Pulling a dent in the side of the bed (2nd Gen)

Hey everyone,

While checking out some trails yesterday, I turned too close to a tree and pushed in part of my bed. The small suction cups I have are not strong enough to pull it out, nor is my plunger at home (Yes, I tried). I was trying to look up how to remove the liner, but learned that this is a composite bed, and there's apparently no liner, it's all just 1 piece. Is there any way to access the inner part of my fender (Is it called a fender on a truck? I'm new here) or do I have to pop it out with a large suction cut or a PDR tool or something?

Thanks everyone!

 

You should be able to reach up from underneath. Removing the wheel well liner will help.

 

I'm an idiot and never even considered going from the bottom. You Mobtown guys are always so helpful, thank you!

 

I'm a super idiot, I don't even really have much in the way of a wheel liner and can just reach up more or less unobstructed. I have a rubber mallet in my truck from banging out a tailgate dent, thanks!

 

Glad you got it sorted out.